POEprotectionstudy.pptVIP

Roger Stout ON Semiconductor POE/POE+ Protection Study Power Over Ethernet Specification Review Power Over Ethernet Plus Specification Review Threat to POE controller Protection Solution for Power Over Ethernet Study Protection Solution for Power Over Ethernet Plus study Power Over Ethernet Specification Review Power Over Ethernet Standard IEEE 802.3af Power Over Ethernet End to End Power Over Ethernet Midspan Electronic Parameters POE Short Circuit Mask POE + Specification Review IEEE 802.3 at Enhanced version of IEEE 802.3 af More Power Output POE and POE + comparison POE + Short Circuit Mask Proposal POE PSE / PD Controller chipset example Linear PSE controller : LTC4263 PD controller : LTC4267 TI PD controller : TPS 2375 PSE controller : TPS 2384 PSE PD system architecture Threat to the POE controller ESD Lighting ESD threat to POE controller ESD Electrical Static Discharge IEC 61000-4-2 specific ESD discharge, contact discharge and air discharge Contact discharge mode level 4 : 8KV Air discharge mode level 4 : 15KV Rising Edge : 1ns Hot-Swap with ESD discharge PSE is power up, and plug-into PD Ethernet port CDE Cable Discharge Event Ethernet Cable is charged when it rubbed against floor, and when it is plugged into the connector, it caused a discharge event Lighting threat to POE controller Standard GR-1089-Core 10x1000us 100A ITU K.21 10x700us 6KV Protection Solution Consideration for POE controller Solution consideration for ESD threat to the POE controller 1SMC58AT3 Response Time Typical 1ns Peak Power - 1500W @ 1ms VRWM =58V, Ir 5uA @ VRWM Protection Solution Consideration for POE controller Solution consideration for Lighting threat to the POE controller (MOV/TVS) Request for MOV / TVS as a solution Clamping voltage : The lower the better Peak Power : 10000W 10x1000us waveform Shortage of the MOV/TVS solution Normally the clamping voltage is around 110V~120V, and this will cause potential risk to the controller MOV Life