运输工具检验程序和密封程序.doc

 Conveyance Inspection Procedures and Sealing Process 运输工具检查程序封条使用过程 Presented by SSCSS Mark Isaacson SCSS Tom Greulich SCSS Mark Mahoney Objectives 目标 ? Systematic 17-point conveyance inspection process 17点系统运输工具检查过程 ? Identifying security breaches 识别安全漏洞 ? Sealing Criteria 密封标准 ? Seal inspection procedures 密封检查程序  17-Point Truck Trailer Inspection 17个货车和拖车检查点 1. Bumper 保险杠 2. Engine 发动机 3. Tires (truck trailer)轮胎（货车和拖车） 4. Floor (inside truck)车厢地面（货车内） 5. Fuel Tanks油箱 6. Cab/ Storage Compartments 驾驶室/存储隔间 7. Air Tanks储气罐 8. Drive Shafts传动轴 9. Fifth Wheel备用轮胎 10. Outside/ Undercarriage外/底盘 11. Floor (inside) 12. Outside/ Inside Doors外面/里面的门 13. Side Walls侧壁 14. Ceiling/ Roof车内天花板/车顶 15. Front Wall前壁 16. Refrigeration Unit制冷装置 17. Exhaust排气管 Conduct a Systematic Inspection 进行系统的检查 Begin and end your inspection at the same point every time. 每次检查时开始和结束于同一点。  Bumpers 保险杠  Point 1 Engine Area 发动机区域  Point 2 Tires 轮胎  Point 3 Tires 轮胎 ? Recently Mounted 最近安装的 ? Tampered Bolts 篡改螺栓 ? Water Streaks 出现水痕  Point 3 Floor车厢底  Point 4 Fuel Tanks/Battery Box 油箱/蓄电池箱  Point 5 Point 5 Fuel Tank Compartment油箱舱 Point 5 Fuel Tank油箱 Point 6 Cab/Sleeper驾驶室/卧车 Storage Compartment存储隔间  Point 6 Air Tanks储气罐  Point 7 Drive Shaft传动轮  Point 8 Fifth Wheel Area 放置备用轮胎区域  Point 9 False Floor in Fifth Wheel  Point 9 Fifth Wheel Area 放置备用轮胎的假底  Point 9 Outside Undercarriage外/底盘  Point 10 False Floor假车底  Point 11 False Floor in Trailer 拖车中的假车底  Point 11 Floor Compartment车底的隔层  Point 11 Door Hardware门用五金  Point 12 Check Hinges检查铰链  Point 12 Side Wall Compartments侧壁隔层  Point 13 Side Walls侧壁  Point 13 Side Wall Kick Panel侧壁踢板  Point 13 Ceiling/Roof车内天花板/车顶  Point 14 Roof Compartments车顶隔层  Point 14 Roof Compartments车顶隔层  Point 14 Front Wall Compartments 前壁隔层  Point