2014年土木工程道路专业优秀毕业设计论文(说明书)资料.docVIP

毕业设计（论文）题 目 专 业 班 级 学 生 学 指导教师 重庆交通大学 年6,127,787元。 此次毕业设计内容主要In this design, our task is to design an secondary road. The road, which is 3083.25m from K0+000.000 to K3+083.25. The design speed is 60km/h and the wide of the subgrade is 10m. construction cost is 6127787 yuan. This graduation design mainly includes route design, subgrade and drainage design, pavement and drainage design, small bridges and culverts design and engineering budget. First of all in the contour map on the tentative route scheme, a wire and determine the alignment index, calculation of pile coordinate, draw the curve graph; longitudinal section design, according to the pile height repeated test slope, section drawing. The design should pay attention to the collocation of longitudinal curve and the plane curve. Design of subgrade cross section, measure ground elevation of subgrade transverse within a certain range, the hat to the cross section using a standard template, and then calculate the cubic meter of earth, protection for special section and reinforcement mainly adopts the retaining wall. Design code for design of drainage design on the basis of drainage and related geological conditions. At the same time, the design of pavement structure, pavement structure design for the design of asphalt concrete pavement, asphalt pavement design is based on the theory of elastic layered system. The first known traffic into the standard axle load calculation of accumulative equivalent time, and give the design deflection value. Using the determined parameters of materials and design deflection value tentatively set the pavement structure layer thickness of each scheme, and the structure of the tensile stress check, the surface layer and the shear strength calculation.Bridges and culverts design, including the design of bri