模拟电子技术课程设计1.docVIP

模拟电子技术课程设计 悬赏分：0 - 解决时间：2010-1-13 02:12 设计一个串联型直流稳压电源，技术指标和要求如下： 1。输出电压U=9-12V可调 2。最大输出电流I=500mA 3。稳压系数Sr≤5% 4。交流电源电压为220V，电网波动±10% 目 录 一、引言...............................................................1 二、设计目的............................................................2 三、设计任务和要求......................................................3 四、设计步骤............................................................4 五、总体设计思路........................................................5 六、实验设备及原器件...................................................6 七、测试要求...........................................................7 八、设计报告要求........................................................8 九、注意事项...........................................................9 十、此电路的误差分析...................................................10 十一、综合总结........................................................11 十二、参考文献资料.....................................................12 一、引言 直流稳压电源一般由电源变压器，整流滤波电路及稳压电路所组成。变压器把市电交流电压变为所需要的低压交流电。整流器把交流电变为直流电。经滤波后，稳压器再把不稳定的直流电压变为稳定的直流电压输出。本设计主要采用直流稳压构成集成稳压电路，通过变压，整流，滤波，稳压过程将220V交流电，变为稳定的直流电，并实现电压可在6-13V可调。 关键词：直流；稳压；变压 Abstract The direct current is steady to press the power supply general from power transformer, commutate the an electric circuit and steady ,press the electric circuit constitute.Transformer the low-pressure alternate current that electric voltage need when changing into in exchanges in electricity in municipal.Commutating the machine change into the direct current to the alternate current.Through the an empress, it is steady to press the machine change into the stable direct current electric voltage exportation to the unsteady direct current electric voltage again. The main adoption in this design is steady to press the slice constitutes to gather steady to press the electric circuit, passing to change to press, commutating, the wave steady ran over the distance an alternate current, change into the stable direct current, a