nrf905无线连接程序.docVIP

热心网友 /******************************************************************************************\============================================================================================* T905.c** This file is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTYT;* without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.*** NOTES:* This program is for the nRF905 with 232 interface;* $write date: 2004.4.7 ;time 11:00$* $Revision: 1 $*/*******************************************************************************************/#include at89x52.h#include intrins.h#define uchar unsigned char#define uint unsigned int#define WC 0x00 // Write configuration register command#define RC 0x10 // Read configuration register command#define WTP 0x20 // Write TX Payload command#define RTP 0x21 // Read TX Payload command#define WTA 0x22 // Write TX Address command#define RTA 0x23 // Read TX Address command#define RRP 0x24 // Read RX Payload command/*******************************************************************************************/typedef struct RFConfig{ uchar n; uchar buf[10];}RFConfig;code RFConfig RxTxConf ={ 10, 0x01, 0x0c, 0x44, 0x20, 0x20, 0xcc, 0xcc, 0xcc,0xcc, 0x58};// The content of this struct is nRF905s initialize data.初始化数据// CH_NO=1;433MHZ;Normal Opration,No Retrans;RX,TX Address is 4 Bytes// RX TX Payload Width is 32 Bytes;Disable Extern Clock;Fosc=16MHZ// 8 Bits CRC And enable/*******************************************************************************************/uchar data TxBuf[32];uchar data RxBuf[32];uchar key,rsbrf,delayf,tf;/*******************************************************************************************/uchar bdata DATA_BUF;sbit flag =DATA_BUF^7;sbit flag1 =DATA_BUF^0;/*******************************************************************************************/sbit TX_EN =P1^7;sbit TRX_CE =P1^6;sbit