4 智能仪表开发-430超低功耗微处理器（二）.pptVIP

序列通道多次转换 ADC模块 The sequence ends after the measurement of the channel with a set ADC12EOS bit and the next trigger signal re-starts the sequence. MSP430F5438的ADC模块 ADC转换如何结束 Resetting ADC12ENC in single-channel single-conversion mode stops a conversion immediately and the results are unpredictable. For correct results, poll the busy bit until reset before clearing ADC12ENC. Resetting ADC12ENC during repeat-single-channel operation stops the converter at the end of the current conversion. Resetting ADC12ENC during a sequence or repeat-sequence mode stops the converter at the end of the sequence. Any conversion mode may be stopped immediately by setting the CONSEQx = 0 and resetting ADC12ENC bit. Conversion data are unreliable. MSP430F5438的ADC模块 ADC中断 The ADC12_A has 18 interrupt sources 18个中断源 · ADC12IFG0-ADC12IFG15 · ADC12OV, ADC12MEMx overflow · ADC12TOV, ADC12_A conversion time overflow ADC12IFG0-ADC12IFG15 The ADC12IFGx bits are set when their corresponding ADC12MEMx memory register is loaded with a conversion result. An interrupt request is generated if the corresponding ADC12IEx bit and the GIE bit are set. 将转换结果写入ADC12MEMx后，产生中断标识，若相应的ADC12IEx 和总中断开关GIE置1，则执行中断程序。 The ADC12OV condition occurs when a conversion result is written to any ADC12MEMx before its previous conversion result was read. 重复写入 The ADC12TOV condition is generated when another sample-and-conversion is requested before the current conversion is completed. 多种SC请求 MSP430F5438的ADC模块 MSP430F5438的ADC模块 ADC中断寄存器 All ADC12_A interrupt sources are prioritized and combined to source a single interrupt vector. The interrupt vector register ADC12IV is used to determine which enabled ADC12_A interrupt source requested an interrupt. MSP430F5438的ADC模块 ADC中断寄存器 中断使能寄存器 中断标志寄存器 MSP430F5438的ADC模块 ADC中断寄存器 MSP430F5438的ADC模块 ADC中断寄存器 中断向量寄存器 MSP430F5438的ADC模块 ADC内部温度计 To use the on-chip temperature sensor, the user selects the analog input channel INCHx = 1010. Any other configuration is done as i