Engineering Design Optimization.pptVIP

Engineering Design: Optimization Engineers design and invent things by using their understanding of the physical world. In this module we will practice the skills of analyzing and designing a system to maximize performance. Prepared by Prof. Dean Wheeler, Brigham Young University, with financial support from the National Science Foundation Alka-Seltzer rocket Supplies: empty 35mm film canister with lid (transparent kind) Alka-Seltzer tablet, broken into fourths water pennies masking tape Team contest Objective: maximize rocket apogee height Variables: amount of water to add and how/whether to use coins and tape on rocket body Rules: (1) only use materials provided (2) get two tries (3) can modify rocket after viewing your and others’ first launch Optimization What, physically, leads to one particular set of conditions where maximum performance is achieved? (discuss) Tradeoff: competing needs or phenomena For example, the addition of more water to the rocket increases how efficiently the rocket produces thrust but decreases amount of stored energy (in the gas). There is a “sweet spot” where the amount of water leads to maximum overall thrust and thus maximum apogee height. Optimize for amount of water In this slow-motion video, you will see a rocket in which too much water has been added. The fly sitting on the side of the rocket is in for a big surprise. No flies were hurt in the making of this movie. The “stuttering” in the rocket’s upward motion is caused by overexpansion of the small amount of gas present, leading to a partial vacuum that tries to reverse the course of the exiting water. Play it again, Sam Optimize for added mass How might added mass affect the rocket apogee height? (discuss) Added mass decreases the rocket velocity following launch (harder to push it), but also gives the rocket more momentum to move through the air friction that opposes it (harder to stop it). There is a tradeoff between these two effects. Depe