挖泥船维修吊机分析报告2.docVIP

图87上、下油缸臂Mises应力云图The Mises stress contour of the main jib cylinder and the knuckle jib cylinder 5.2.3 支座反力Reaction force 对于有限元模型的中枢底部截面，得到的主要反力大小为： As to the finite element of the king structure, the major forces are: 力矩：167.41tm Moment: 167.41tm 竖向反力：34.43t Vertical reaction force: 34.43t 水平反力：0 Vertical reaction force: 0t 5.2.4 副臂架The knuckle jib 副臂架的受力情况如图88-图91所示。 The stress of the knuckle jib are shown in Figure 88 - Figure 91. 副臂架的最大Mises应力约为78.4MPa，在上油缸臂拐角处。 The maximum stress appears at the inner corner of the knuckle jib, and the Mises stress is about 78.4Mpa. 在绞盘（吊点）处，当底板加强以后，应力大值将出现在铰点邻近区域。 When the base plate is strengthened, thebig stress appears at the nearby place of the winch (the lifting point). 在上油缸臂上铰点处，当底板加强以后，应力大值将出现在铰点邻近区域，并且内部拐角处有较明显的应力集中。 When the base plate is strengthened, thebig stress appears at the nearby place of the hinge, and the stress concentration appears at the inner corner. 副臂架与主臂架铰点处耳板的应力较小。 The stress in the bracket of the main jib and the knuckle jib is small. 图88副臂架应力云图The stress contour of the knuckle jib 图89绞盘（吊点）处应力云图The stress contour of the winch (the lifting point) 图90上油缸臂上铰点处应力云图The stress contour of the hinge of the knuckle jib cylinder to the knuckle jib 图91主臂架-副臂架铰点处应力云图The stress contour of the hinge of the main jib to the knuckle jib 5.2.5 主臂架The main jib 主臂架的受力情况如图92-图96所示。 The stress of the main jib are shown in Figure 92 - Figure 96. 主臂架的最大应力约为98.5MPa，在下油缸臂上铰点处。 The maximum stress appears atthenearby place of the top hinge of the main jib cylinder, and the Mises stress is about 98.5 Mpa. 在上油缸臂下铰点及下油缸臂上铰点，当底板加强以后，应力大值出现在铰点邻近区域。 When the base plate is strengthened, thebig stress appears at the nearby place of the hinge, both the main jib cylinder andthe knuckle jib cylinder. 中枢与主臂架铰点、主臂架与副臂架铰点处的应力均较小。 Thestress at the hinge of the knuckle jib cylinder to the main jib, and the hinge of the main jib cylinder to the main jib is relatively small. 图92主臂架应力云图The stress contour of the main jib 图93上油缸臂下铰点处应力云图The stres