CDMASystemoverview详解.pptVIP

模块化基站是网络中负责从移动交换中心（MSC）到移动终端之间空中接口操作 的网元。模块化基站在网络中的位置如下图描述 . RCS 提供与它相关联的各基站的配合和控制。RCS 是运行在应用处理器（AP）上 的应用。AP 是位于MSC 的高性能计算机节点，它可以同时执行几个RCS 应用。 Modcell Traffic channel -? Packet Pipe. (Frame Relay) Signaling Channel----? 5ESS nail up -? AP Composition and function of ECPC Capacity of ECPC Function of ECP Hardware of ECP Structure of IMS ring and function of each nodes IMS ring capacity Hardware of IMS ring 7 Function of AM 7 AM: 双备份 CU/DFC/IOP Rack: CSPC,CSPGC CM: blue and white optical fibric 9 SM: T-S-T 10 The packet pipe terminates through a digital facility Interface (DFI) to a frame relay protocol handler (PH4/FRPH) in the PSU2. The FRPH takes packets from the packet pipe and transfers them to the packet bus to be sent to the protocol handler for Voice (PHV). If the PHV resides on a different PSU, the packets travel through the PHA over ATM interconnect platform to the correct PHV. The function of the PHV is to receive packets from the MS, select the “best” voice quality packet, convert the variable length packet to 64Kbps circuit switched pulse code modulated (PCM) voice, and sent it to the PSTN. From the 5ESS-2000 standpoint, the new hardware needed to support CDMA design are the FRPH, PHV, and PHA Code Division Multiple Access CDMA - Digital access using spread spectrum or wide spectrum system that uses a “code” for each conversation to pull only one conversation out of all the others being transmitted over the same frequency. 11 Three kinds of protocol handler example PP list A 3,600 trunk 5ESS-2000 Switch requires a SM-2000 which consists of a SMC (Switching Module Cabinet) and 2 LTP (Line and Trunk Peripheral) Cabinet. 06/15/98 6 MSC NPI Methods Engineering AP均为成对配置以保 证高可靠性。 - 与ECPC连接 每个AP通过AP机架（APF）中的AP和IMS环机架中的 EIN节点间的点 到点以太网连接到ECPC/IMS。每个AP连接到一个EIN。EIN处理来自/去往ECP的 IMS消息。 - OMP 连接 通过以太网和OMP相连。（连到NETRA 1120 背后的Ethernet/SCSI综合卡） - 与5ESS连接 通过E1，2兆线和5ESS相连。基站也通过E1连到达ESS。在5ESS中的时隙作半固连接，把从基站来/去的信令送到AP处理。 REVIEW NEW ARCHITECTURE APs a