基于单片机的自动窗帘设计教程分析.doc

目 录 中文摘要 I 英文摘要 II 1 绪论 1 1.1 课题背景 1 1.2 国内外概况 1 1.3 课题的研究工作 2 2 系统总体方案设计 4 2.1 系统总体硬件方案 4 2.2 系统总体软件方案 5 2.3 单片机编程语言 5 2.4系统软件编译器WAVE介绍 5 3 系统硬件方案设计 7 3.1 STC15F408AD单片机 7 3.2 按键模块设计 9 3.3 LED数码管 10 3.4 驱动电路设计 11 3.5 三极管 12 3.6 光敏电阻 13 3.7 自动窗帘控制系统的制作及工作原理介绍 13 4 系统软件方案设计 15 4.1 概述 15 4.2 主程序设计 15 4.3 显示程序的设计 16 4.4 按键模块程序设计 17 4.5 传感器模块程序设计 18 4.6 控制模块程序设计 18 5 电路板制作 19 6 系统调试 20 6.1硬件电路部分的调试 20 6.2软件部分的调试 21 6.3 调试结果 22 总 结 23 致 谢 26 参考文献 27 附录1 电路原理图 28 附录2 元器件清单 29 附录3 主要程序代码 30  基于单片机的自动窗帘控制 摘 要  BASSED ON SINGLE CHIP AUTOMATIC CURTAIN CONTROL Abstract Automatic control belongs to an important branch of electronics and information science , and has good prospects for development in the current modern home . Currently , light and dark family living environment problem is mainly used to manually open and close the curtains , manually opening and closing a lot of respect not only laborious but not human , it may cause some problems for users, curtain control system can solve these problems. This paper reviews the design and production process control system for automatic curtains , introduces the theoretical analysis to design a complete curtain control systems need to do as well as its production process. Automatic curtain control system core uses a microcontroller STC15F408AD.Second, the use of a light sensor , keyboard and display interface circuit and signal conditioning circuitry and other peripheral circuits , automatic control, timing control. The design at the theoretical level , the programming language used to drive each module to achieve inner link system at the application level, then using Protel software for schematic design . Constitute automatic curtain control system mainly consists of light sensing circuit , system control module circuit , power conversion circuits , motor control circuit, keyboard and display circuits and other components , focusing on the design process curtain automatic control system , hardware selection and sof