潜栅凸轮衬套塑料注射模的设计与分析.docxVIP

 PAGE 2 Mohd Jamsheed et al. / Materials Today: Proceedings 2 (2015) 2083 – 2093 Available online at  HYPERLINK / \h  ScienceDirect Materials Today: Proceedings 2 (2015) 2083 – 2093 4th International Conference on Materials Processing and Characterisation (ICMPC 2015) Design and Analysis of Plastic Injection Mould for CAM BUSH with Submarine Gate MohdJamsheeda*MdAaqibRahmanb M.A MoyeedcG.M.SayeedAhmedd aAssistantProfessors,Dept. of Mechanical Engineering, VIF college of Engineering and technology. Assistant Professorsb,Mechanical Engineering. NawabshahAlam Khan college of Engineering, cAssistant ProfessorsDept. of Mechanical Engineering, NawabshahAlam Khan college of Engineering., dSenior Assistant Professors, Dept. of Mechanical Engineering, M. J.Collegeof Engineering and technology, Abstract ? 2014 The Authors. Elsevier Ltd. All rights reserved. Selection and peer-review under responsibility of the conference committee members of the 4th International conference on Materials Processing and Characterization This Paper focused on Design and Analysis of an automatic plastic injection mould for production of CAM BUSH. Cam Bush is used as a indexing device in ON/OFF Load Tap changer device of high voltage transformer and serves as the connector between the indexing head and the power changing gears. An injection mould is a tool which is used for production of plastic components in large numbers in a short span of time. Modeling in done by using Unigraphics (NX 7.5) and Auto Desk Mould flow Plastic Insight is use for Mould flow Analysis for CAM BUSH filling rate, cooling system location and Location of submarine gate. The moulding tool consists of the Top plate, Cavity plate, Core plate, Spacer blocks, Ejector plate and the Bottom plate. In this six core pins and six ejector pins are provided on injection mould because the required cam bush has six indexing holes. The material use is Oil Hardened Non-shrinking Steel (OHNS) for the core and cavity, and EN353 for