基于MATLAB的三相整流电路的设计精要.docVIP

华东交通大学理工学院 Institute of Technology. East China Jiaotong University 课 程 （论 文） 题 目 基于MATLAB的三相整流电路的设计 分 院： 电信分院 专 业： 12电牵 班 级： 1班 学 号： 20120210470512 学生姓名： 姚涛 指导教师： 李房云 起讫日期： 2015年11月19日  摘 要 在对三相桥式半控整流电路和三相桥式全控整流电路作出理论分析的基础上 建立了基于 MATLAB/Simulink 的三相桥式整流电路的仿真模型，并对其带纯电阻负载及电阻电感性负载时的工作情况进行对比分析与研究 。用 MATLAB 软件自带的 Power System 工具箱进行仿真 给出了仿真结果， 验证了所建模型的正确性。本文主要介绍三相桥式全控整流电路的主电路和触发电路的原理及控制电路图,由工频三相电压380V经升压变压器后由SCR(可控硅)再整流为直流供负载用。但是由于工艺要求大功率,大电流,高电压,因此控制比较复杂,特别是触发电路部分必须一一对应,否则输出的电压波动大甚至还有可能短路造成设备损坏。Abstract In the three-phase bridge type half controlled rectifier circuit and three-phase bridge type all control rectifier circuit to make a theoretical analysis on the basis of the established based on MATLAB /Simulink simulation model of three-phase bridge rectifier circuit And their resistance with pure resistive load and inductive load working condition were analyzed and the research In MATLAB software comes with Power System toolbox simulation gives the simulation results validate the correctness of the model. This paper mainly introduces the three-phase bridge type all control the rectifier circuit principle of main circuit and the trigger circuit and control circuit diagram, the three-phase power frequency voltage 380 v after step-up transformer by SCR rectifier (SCR) for dc for load. But because the process requires high power, high current, high voltage, so the control is more complex, especially the trigger circuit parts must be one to one correspondence, otherwise the output voltage fluctuation of big perhaps even short-circuit equipment damage. Key words Three-phase bridge type half controlled rectifier Three-phase bridge type all control rectifier thyristor trigger Angle 目 录 中文摘要…………………………………………