大学毕业设计论文pcm系统仿真设计【定稿】.docVIP

论文题目：PCM系统仿真设计 摘要 当信源为模拟信号时，在发端需要进行模/数变换，即经抽样、量化、编码，对其幅度和时间离散化处理，使之变成数字信号后再进行传输；在收端将收到的数字信号进行数/模变换，使之还原成模拟信号再送至信宿。 本文主要研究了本文主要研究了PCM系统基于Matlab和Simulink仿真设计,通过使用Matlab和Simulink PCM编码和解码系统的建模和仿真,结果与理论分析是一致的。 【关键词】PCM;MATLAB/Simulink;仿真 Title: The design of PCM system Abstract When the source is an analog signal, the originator need for analog / digital conversion, which is a sampling, quantization, coding, its amplitude and time discretization, and then make it into a digital signal for transmission; at the receiving end will receive the digital signal for digital / analog conversion, so that t