信实德电除尘优化控制设备分析报告.ppt

国投广西北海发电厂电除尘监控画面 Wotrustek—节能减排专家 国投广西北海发电厂电除尘监控画面 Wotrustek—节能减排专家 国投广西北海发电厂电除尘监控画面 社会性及经济性收益 北京信实德的控制设备与传统控制设备相比，可取得良好的社会及经济效益： 灰尘的绝对排放可减少40%以上； 电耗可减少20%以上； 振打时间可减少15%以上。 介绍完毕 谢谢！ The figure shows a detail of a collecting electrode, including collected dust layer. A stream of ions (and freshly charged dust) arrives continously from the discharge electrodes, representing an electric current of between 0.1 and 0.5 mA per square meter of collecting surface. The current must pass the layer of dust in order to reach the collecting electrode. The resistivity of the dust results in a voltage drop over the dust layer and the creation of an electric field within it. Ohm′s law gives this relation: E=R*I, where E=strength of electrical field, R=resistivity, I=current density. The form and slope of the I/U-curves is depending on process parameters such as dust resistivity, grain size, inlet dust load, temperature and moisture. *The slope of the curves is depending on resistivity and temperature. * The voltage is increasing for increasing dust loads, therefore the voltage is higher in the front field than in the rear ones. * The flash over voltage is increasing for decreasing temperatures. * The flash over voltage is increasing for increasing moisture contents. I.e. the flash over voltage is proportional to the flue gas density, the higher the density, the high over voltage. The form and slope of the I/U-curves is depending on process parameters such as dust resistivity, grain size, inlet dust load, temperature and moisture. *The slope of the curves is depending on resistivity and temperature. * The voltage is increasing for increasing dust loads, therefore the voltage is higher in the front field than in the rear ones. * The flash over voltage is increasing for decreasing temperatures. * The flash over voltage is increasing for increasing moisture contents. I.e. the flash over voltage is proportional to the flue gas density, the