美国UBNTwifi设备WDS器接入点AP设置方法.docxVIP

WDS Repeater Access Point AP Offer comments, ask questions and join the discussion on this topic in the Ubiquiti Support Forum: [ HYPERLINK /showthread.php?t=51900 \o /showthread.php?t=51900 [1]] Create an expanded-area Wi-Fi Hotspot using M2 radios that is capable of supporting up to 50 (max) nearby, traditional Wi-Fi clients for each Access Point in the cluster.  Configuring an Expanded Area Wi-Fi Hot Spot Accessing the Radio: 1. Restore your radio to FACTORY DEFAULT values. This is critical, especially if you are troubleshooting a problem. 2. Connect the radio to your computer using an Ethernet cable. The Ethernet port is auto-sensing. You are not required to use a cross-over cable. 3. Using a web browser, enter 0 as the URL to gain access to the radios management console. 4. Enter ubnt as the administration account and ubnt as the password. Configure the radio labeled as IP = above: A. Choose the |Wireless| tab, and change only: Wireless Mode: AP-Repeater WDS Peers: AA:BB:CC:00:00:03 (Example only. Use the actual MAC address of the OTHER radio) Channel Width: 20 MHz Frequency: Choose one from the list. NOTE: Channel 1 = 2412, Channel 6 = 2437, Channel 11 = 2462 Press [Change] button B. Choose the |Network| tab, and change only: IP Address: Press [Change] Button C. Choose |Ubiquiti Logo| tab AirMax: [ ] enable (UN-check) Press [Change] Button, Press [Apply] Button DONE with this radio. Repeat 1-4 with the second radio, then continue below. Configure the radio labeled as IP = above: D. Choose the |Wireless| tab, and change only: Wireless Mode: AP-Repeater WDS Peers: AA:BB:CC:00:00:02 (Example only. Use the actual MAC address of the OTHER radio) Channel Width: 20 MHz Frequency: Choose THE SAME frequency that you chose above. Press [Change] button E. Choose the |Network| tab, and change only: IP Address: Press [Change] Button F. Choose |Ubiquiti Logo| tab AirMax: [ ] enable (UN-check) Press [Change] Button, Press [Apply] Button DONE If using a Cable/DSL M