基于单片机系统的胎压检测详细分解.docVIP

毕业设计（论文） 题 目：基于单片机的胎压测试系统的设计与实现系 别： 专 业： 学生姓名： 指导教师： 2014年月 日 摘 要 本文完成了胎压测试系统的设计与实现。实现了测试汽车轮胎压力的功能，由三种不同的计量单位通过LCD显示给用户，如果超出预设阈值就会发出警报提醒司机安全行驶。另外，在正常状态下可实时显示日期和时间，有断电保护功能，并可对日期和时间进行设置。 首先硬件采用气压传感器MPX4105、STC5A60S2单片机、DS1302 时钟电路和1602LCD等。通过气压传感器MPX4105获取与汽车胎压相对的模拟电压值，经过V/F变换输入到单片机进行处理，最终由通过LCD显示电路显示相应气压值。另外，DS1302时钟电路与单片机连接实现了LCD显示日期和时间，并可断电保护的功能。 其次采用C语言作为开发工具软件，在Keil C环境下进行了对单片机各个端口以及定时器工作方式和串行口工作方式进行设置，并对定时器和串行口进行初始化用以实现对单片机和各个功能模块芯片之间通讯和联络的设定，以及分配地址空间交代程序中各个变量等的设计和编码。 最后完成系统的可靠性、稳定性等性能的测试。压力超出阈值会自动报警提醒驾驶员安全行驶。不工作状态下，可显示日期与时间并有断电保护功能。具有可携带、测试操作方便、价格低廉等优点。 关键词： Abstract This paper completed a tire pressure measurement system. It realizes the function of the test tire pressure. It from three different units of measurement through the LCD display to the user, if you exceed a preset threshold alerts will remind drivers to drive safely. In addition, in the normal state it can be real-time display date and time. There is power failure protection and on the date and time settings. First of all, hardware used pressure sensor MPX4105, STC5A60S2 single chip, DS1302 clock circuit, 1602LCD and so on. The pressure sensor MPX4105 and automotive tire pressure relative to the analog voltage value, after the V / F transform the input to the microcontroller for processing, and ultimately by the circuit through the LCD display shows the corresponding pressure values. Besides, DS1302 clock circuit and microcontroller connection to display the date and time and power protection. Secondly, as a development tool with C language software, Keil C environment for all ports of microcontroller and timer mode set the serial port work, it initializes the timer and serial port to achieve each function module chip microcontroller, it explains the program address space allocation of the variables such as the design and coding. Finally, to complete the system reliability, accomplished stability and other properties of the test. Pressure above the threshold will automatically alarm t