重要机床电气与PLC(英文)剖析.ppt

6.1.2Rules of ladder program In each logic line, serial contacts should be placed on the top. Parallel contacts circuits should be placed on the left. Do not allow a two-way current contact to pass When more logical lines are on the same conditions, it often combined these logical line. Chapter 6 Application and Program of PLC (1)Three-phase asynchronous motor launch, maintain and stop circuit. 6.1.3Basic common ladder programming Chapter 6 Application and Program of PLC 6.1.3Basic common ladder programming (2)Positive and reverse control circuit of three-phase asynchronous motor Chapter 6 Application and Program of PLC (3)Circuit of two motor timeshare start One motor will start firstly, another motor will start 20 seconds later, then two motors will stop at the same time. (4)Circuit expanding the scope of regular timer Chapter 6 Application and Program of PLC 6.1.4 Ladder map design by experience PLC completed the use of automatic control of vehicles PLC completed three motor cycle control of running, starting and stopping. The ladder steps of experience design Chapter 6 Application and Program of PLC Exchanges in the relay circuit generally control by output relay of PLC, the coil connects to the output of PLC. Button, speed controller, limit switch provide control order and feedback signals to the PLC , and their contacts connect to the input of the PLC, generally using normal open contacts. The functions of middle relay and time relay in relay circuit is completed by auxiliary relays and timers within PLC, they has nothing to do with their input and output of PLC. 6.1.5 Design ladder procedures by the relay circuit Chapter 6 Application and Program of PLC 6.1.5 Design ladder procedures by the relay circuit Obey the grammar of the ladder language Set intermediate unit Minimize the input and output points of PLC Design PLC external chain Circuit Individual contact should be placed right, a single contact in parallel circuit should be placed below. Rated vol