ccna 2 chapter 9 v5.0 exam answers 2013精要.docxVIP

1 A network administrator needs to configure a standard ACL so that only the workstation of the administrator with the IP address 3 can access the virtual terminal of the main router. Which two configuration commands can achieve the task? (Choose two.) Router1(config)# access-list 10 permit 3 Router1(config)# access-list 10 permit 3 * Router1(config)# access-list 10 permit 3 55Router1(config)# access-list 10 permit 3 55Router1(config)# access-list 10 permit host 3* 2 Refer to the exhibit. A router has an existing ACL that permits all traffic from the network. The administrator attempts to add a new ACE to the ACL that denies packets from host and receives the error message that is shown in the exhibit. What action can the administrator take to block packets from host while still permitting all other traffic from the network? Manually add the new deny ACE with a sequence number of 5.* Manually add the new deny ACE with a sequence number of 15.Add a deny any any ACE to access-list 1.Create a second access list denying the host and apply it to the same interface. 3 Launch PT ? – ? ?Hide and Save PTOpen the PT Activity. Perform the tasks in the activity instructions and then answer the question. Why is the ACL not working? The ACL is missing a deny ip any any ACE.The ACL is applied in the wrong direction.The access-list 105 command or commands are incorrect.The ACL is applied to the wrong interface.* No ACL is needed for this scenario. 4 Which statement describes a characteristic of standard IPv4 ACLs? They are configured in the interface configuration mode.They can be created with a number but not with a name.They filter traffic based on source IP addresses only.* They can be configured to filter traffic based on both source IP addresses and source ports. 5 Refer to the exhibit. The network administrator that has the IP address of 3/25 needs to have access to the corporate FTP server (/28). The FTP server is also a web server that is accessible t