基于单片机的无线充电器设计剖析.docVIP

基于单片机的无线充电器设计 学生姓名： 学生学号： 院 （系）： 电气信息工程学院 年级专业： 电子信息工程 指导教师： 助理指导教师： 二〇一五年五月  摘 要 随着用电设备对供电质量、可靠性、方便性、安全性、特殊场合、特殊地理环境等要求的不断提高，接触式电能传输方式实际需要无线电能传输系统，具有无线传输电能、设备体积小、传输效率高、便于携带和集成等优点STC12C5A60S2低功耗单片机作为无线传能充电器的监测控制核心,实现电流控制和电压控制功能，电能充满后给出充满提示且自动停止充电。基于STC12C5A60S2单片机控制发射端和接收端产生的相应交流信号来进行充电的智能无线充电器。 利用设计通过对系统的硬件部分和软件部分的设计实现无线能量传输距离发射线圈建立谐振耦合无线电能传输系统模型谐振耦合无线电能传输系统模型,得出了系统中电路参数与输出功率的关系。设计并制作谐振耦合无线电能装置, ABSTRACT This paper introduced the use of a power transmission technology, wireless power supply technology model, using the principle of electromagnetic induction and the induction technology,intelligent wireless charger for charging the AC signal based on the STC12C5A60S2 single-chip microcomputer to control the transmitting end and the environment and other requirements continue to increase, the power transmission mode of contact to meet the actual needs become more and more difficult. At the same time, wireless power transmission system, get rid of the limit line, completely separate electrical and power, with the wireless transmission of electrical energy, the equipment has the advantages of small volume, high transmission efficiency, easy to carry and integration. In the rapid development of science and technology in 21 Century, the prospects for the development of intelligent wireless charger . The design through the design of the hardware part and the software part of the system to achieve the wireless energy transmission, within the specified range of the transmitting coil in small appliances such as mobile phone, MP3 and other direct charge. The hardware part includes efficient DC power module, drive module, display module, control module and so on; the software part is mainly based on the design thought of the system design of the main program and the subprogram flow chart, and through the C language to achieve the correspon