typeinspectionreport-Anac.doc

TYPE INSPECTION REPORT Part 1 – Airplane Ground Inspection INSTRUCTIONS This form is to be used to record the results of conformity inspections and investigations of prototype or modified airplane presented for type certification. Many inspections and tests will be witnessed or participated in which are not covered by questions listed herein. All such inspections and tests and changes to the product and/or type design data resulting therefrom must be recorded and made a part of this report. This form includes references to applicable RBHA. Some sections are interrelated, and future RBHA revision may modify the requirement of an item. It is essential that the specific RBHA’s applicable to the airplane involved be reviewed to insure a complete and effective inspection. When this form is used in conjunction with a program which involves an airplane being certificated under a CAR, cross out the RBHA reference and enter the equivalent CAR reference. All entries must be clear, concise, and self-explanatory. Answer questions in this report by checking the appropriate “YES” or “NO” column. When action is required to render the item acceptable, check “ACTION REQ.” Use additional pages to list the unsatisfactory conditions found during the inspection with reference to any communication or conformity inspection reports relative to the item. Number the pages with the page number on which the question appears plus a letter, i.e., 10a, 10b, etc. Identify the unsatisfactory condition by using the related item number as it appears on the form; list numerically with sufficient space between each entry to note the corrective action taken. When the item has been reinspected, cross out the previous “NO” answer and enter the new answer. This will be done for each inspection until the item is acceptable and will serve as a record of the number of times the item was inspected prior to acceptance. When a question is not applicable to the product being inspected, enter “NA” a