电力电子技术课程设计-三相桥式全控整流电路的研究.docVIP

摘 要 电子技术的应用已深入到工农业经济建设交通运输空间技术国防现代化医疗环保和亿万人们日常生活的各个领域进入21世纪后电力电子技术的应用更加广泛因此对电力电子技术的研究更为重要。近几年越来越多电力电子应用在国民工业中,一些技术先进的国家,经过电力电子技术处理的电能已得到总电能的一半以上。 本文主要介绍三相桥式全控整流电路的主电路和触发电路的原理及控制电路图,由工频三相电压380V经升压变压器后由SCR(可控硅)再整流为直流供负载用。但是由于工艺要求大功率,大电流,高电压,因此控制比较复杂,特别是触发电路部分必须一一对应,否则输出的电压波动大甚至还有可能短路造成设备损坏。 本电路图主要由芯片C8051-F020微控制器来控制并在不同的时刻发出不同的脉冲信号去控制6个SCR。在负载端取出整流电压,负载电流到C8051-F020模拟口,然后由MCU处理后发出信号控制SCR的导通角的大小。 在本课题设计开发过程中,我们使用KEIL-C开发软件,C8051开发系统及PROTEL-99,并最终实现电路改造设计,并达到预期的效果。MCU； SCR；电力电子导通角KEIL-C ABSTRACT The application of electronic technology has deep into the industrial and agricultural economy construction, transportation, space technology, national defense modernization, medical, environmental protection, and millions of Peoples Daily life in all areas, after 21 st century power electronic technology application more extensive, so the power electronic technology research is more important.In recent years more and more application in the national power electronics industry, some technical advanced countries, after power electronic technology processing power has been more than half of total power.This paper mainly introduces the three-phase bridge type all control the main circuit of rectifier circuit and trigger circuit principle and control circuit, the power frequency voltage 380 V the boost phase after transformer (SCR) again by SCR rectifier for dc load for use.But because the process requirement high power, large current, high voltage, and hence control is more complex, especially trigger circuit part must be exactly corresponding, otherwise the output voltage fluctuations and may have even large short-circuit equipment damage.The main circuit by chip C8051-F020 micro controller to control and in different time a different pulse signal to control six SCR. In both the load remove rectifier voltage, load current C8051-to F020 simulation mouth, then by MCU after processing signal control SCR conduction Angle of size.In this topic in the design process, we use the