OEM开发流程.ppt

OEM開發流程簡介OEM DEVELOPMENT PROCEDURE BRIEF INTRODUCTION 1、設計階段(DESIGN PHASE) 2、開發階段(DEVELOPMENT PHASE) 3、量試階段(MASS PRODUCTION PHASE) 4、Q A 1.設計階段(DESIGN PHASE) 1-1.DFMEA檢討(DFMEA DISCUSSION) *找尋過去相似燈具失敗經驗 (SEEKING FOR SIMILAR FAILURE MODES BEFORE) *找尋此燈具使用之通用件過去失敗經驗 (SEEKING FOR THE SIMILAR FAILURE MODES FOR USING THIS COMMON PARTS) *將收集之失敗經驗檢討並設計改善之 (COLLECTION OF FAILURE MODES FOR DISCUSSION AND RE-DESIGN FOR IMPROVEMENT) 1.設計階段(DESIGN PHASE) 1-2.市場件(標竿)評估比較 (CONDUCTING BENCHMARKING) *市場件選定 (SELECTION OF BENCHMARKING TARGETS) *市場件之優缺點資訊收集 (THE INFORMATION OF BENCHMARKING SAMPLES  ADVANTAGE AND SHORTCOMING)  *市場件性能評估 (THE EVALUATING OF BENCHMARKING DURABILITY) *市場件之優缺點納入DFMEA中檢討改善 (ADOPT THE BENCHMARKING SAMPLES ADVANTAGE AND  SHORTCOMING TO DFMEA DISCUSSION AND IMPROVE) 1.設計階段(DESIGN PHASE) 1-3.設計審查 (DESIGN CHECK) *圖面標記審查 (DRAWING MARKINGS CHECK) *設計公差審查 (DESIGN TOLERENCE CHECK) *管制點審查 (CONTROL POINTS CHECK) *客戶要求審查 (CUSTOMER REQUIREMENT CHECK) 1.設計階段(DESIGN PHASE) 1-4.設計驗證 (DESIGN VERIFICATION) *使用CAE電腦模擬驗證設計性能是否符合客戶需求 (USING COMPUTER SIMULATION VERIFICATION DESIGN CAE (Computer Assistant Engineering)  TO PROVE THE PROPERTY CAN BE MET TO  CUSTOMER REQUIREMENT) 2.開發階段(DEVELOP PHASE) 2-1.模具製作(TOOLING DEVELOPMENT) *模具依產能,壽命要求規劃設計 (TOOLING DESIGN BASED ON PRODUCTIVITY AND LIFE  REQUIREMENT) *依設計製造模具並使用量測工具驗證之 (TOOLING DEVELOPMENT BASED ON DESIGN AND USING  MEASURE KIT TO VERIFY) *驗證符合規格後試模驗證之 (DIMENSIONS CHECK OK THEN USING TRAIL INJECTION TO PROVE OUT) *試模問題改善後驗證 (THE VERIFICATION OF TRAIL INJECTION PROBLEMS  IMPROVEMENT) *初期製程能力分析驗證穩定力 (THE STABILITY OF INITIAL PRODUCTION CAPABILITY  ANALYSIS VERIFICATION) 2.開發階段 (DEVELOP PHASE) 2-2.PFMEA檢討 (PFMEA DISCUSSIO