抽油烟机培训资料.pptVIP

* 基于标准UL507 2003版 抽油烟机培训教材 触电危险; 防火危险 过热危险 机械危险 爆炸危险 辐射危险 其他危险 ※ part 1 结构评估 UL安全认证考虑的因素 CONSTRUCTION 6 Frame and Enclosures 6.1 General 6.1.1 An appliance shall be formed and assembled so that it has the strength and rigidity necessary to resist the abuses to which it is subjected, without causing a risk of fire, electrical shock, or injury to persons due to total or partial collapse with a resulting reduction of spacings, loosening or displacement of parts, or other serious defects. 6.1.2 A cast- or sheet-metal section of the enclosure shall not be thinner than the applicable value specified in Table 6.1. Exception No. 1: A small area or surface that is curved or otherwise reinforced to provide equivalent mechanical strength is not required to comply with the specifications in the first column of thicknesses in Table 6.1. Exception No. 2: A section of the enclosure made of uncoated or galvanized sheet steel or cast malleable iron shall not be thinner than the specifications in the first column of thicknesses in Table 6.1 unless such factors as the following are determined to be acceptable: ※ part 1 结构评估 外壳基本要求 6.4.1 Polymeric material used to enclose a metal housing that encloses insulated or uninsulated live parts, or used as a decorative part, shall be classed either 5VA, 5VB, V-0, V-1, V-2, or HB by the burning tests described in the Standard for Tests for Flammability of Plastic Materials for Parts in Devices and Appliances, UL 94. PCB板盒的外壳胶料需UL认证，最少ＨＢ级别 6 Non-metallic parts other than enclosures PCB的要求 Flame Spread and Smoke Developed Requirements for Non-Metallic Enclosures and Other Parts of Permanently Connected Equipment (not applicable) Clause 7 外壳塑胶材料的要求 Clause 8 产品安装后，测试棒不能通过吸油烟的口及其他外部孔触及运动部件． 当进风孔与运动部件距离大于25.4 mm时，则孔直径最大38.1 mm. 当进风孔与运动部件距离小于25.4 mm时，则测试棒不能通过该孔触及运动部件． 关于触及运动部件的要求 Clause 8 关于测试棒 Clause ９ 关于带电部件的保护 Clause 10 关于装配要求 1) 关于产品中元器件的安装与固定，应防止自由的滑动， 松脱，旋转等现象的发生． 2) 内部引线的连接，装配后不应承受拉伸等应力． １）抽油烟机，应作为永久连接供电方式的产