建筑机械钢筋切断机毕业机械CAD图纸设计.doc

摘 要 本课题的主要内容是针对建筑机械钢筋切断机的设计进行的。在市面销售的钢筋切断机成品上面进行了测绘计算，然后使用CAD软件绘制出其全部零件的零件图及装配图，零件图上要标注公差、表面粗糙度等等技术要求，然后进行能量、功率，转矩的分配计算，能量由电动机和双飞轮供应，飞轮是本次毕业设计的一个重点难点，由切割所需功率算出飞轮需要提供的功率，然后利用现有飞轮尺寸校核速度波动校核飞轮是否符合要求。然后在其减速机构上进行传动比分配计算，并核对其合理性。然后进行V带传动设计校核计算，齿轮传动的设计校核计算，轴的弯矩扭矩的计算、弯矩扭矩图的绘制和轴的强度校核，键的强度校核计算。 关键词：飞轮，V带传动，齿轮传动，轴，键 Abstract The main content of this thesis is aimed at building machinery reinforced cutting machine design. Cutting machine products in the steel market sales of Surveying and mapping the above calculation, and then use the CAD electronic chart drawing parts drawing all of its parts and assembly drawing, part drawings to tolerance, surface roughness requirements, technology, and energy, power, computed torque distribution, energy supply by the electric motor and the flying wheel, the flywheel is a key point in this graduation design, calculate the flywheel power need to provide the required by cutting, and then use the existing flywheel size check whether it meets the requirements of the flywheel speed fluctuations. And then drive in the retarding mechanism than distribution calculation, and verify its rationality. Then V belt driving design calculation, design and calculation of gear drive, strength check calculation, drawing and the axis of bending moment of torque shaft bending moment diagram of torque, the strength calculation check key. Keywords: flywheel, V belt transmission, gear, shaft, key 目 录 1 引言………………………………………………………………………………1 1.1 钢筋切断机的研究意义………………………………………………………1 1.2 钢筋切断机的发展动向………………………………………………………1 1.3 GQ40A型钢筋切断机基本参数……………………………………………1 1.4 切断机的同步机构的设计……………………………………………………2 1.4.1 整台机器运动模式简图 …………………………………………………2 1.4.2 减速机构的设计……………………………………………………………2 1.4.3 剪切部位的设计……………………………………………………………4 2 切断机的工艺设计………………………………………………………………5 2.1 剪切力的计算…………………………………………………………………5 2.2 曲柄、连杆、滑块的受力分析………………………………………………6 2.2.1 滑块所受的力……………………………………………………………6 2.2.2 曲轴受力分析……………………………………………………………7 2.3 飞轮的校验计算………………………………………………………………14 2.3.1 飞轮的功率计算…………………………………………………………14 2.3.