角片套冷冲压工艺及级进模机械CAD图纸设计论文.doc

摘 要 关键词： Abstract The die by cutting waste stamping, die structure incision, drawing, red pilot hole, drawing guide, cut waste, bending, the cut process design, arranged in a single row of horizontal nesting.And dress design the die structure, the die attached to the lower die part, in order to properly control the feeding step unilateral side of the blade fixed pitch, in the main location pilots to precise positioning.As the material is thin, stamping speed, the discharge may be used in the elastic unloading structure, it is recommended that the elastic material with spring. Waste using the die (down die) launched down the final product is lower die down soon.Strip automatic feeding device left and right side pressure. In order to properly control the feeding step away from the side of the blade fixed pitch. As the material is not very thick, stamping moderate speed, the discharge elastic unloading structure, elastic material with rectangular cross-section spring.The waste products are used down soon.Automatic feeding device with material from right to left. Stamping process analysis consider the stamping process, most notably including the technical and economic aspects.On the technical side, according to the product drawings, mainly analyzes the characteristics of the shape of parts, size, accuracy requirements and material properties and other factors meets the requirements of the stamping process;In economic terms, mainly based on the production volume of the stampings, analyze the cost of the product, and clarify the use of the stamping production can be achieved economic benefits.Process analysis, mainly to discuss stamping out does not affect the part of the premise, the simplest and most economical way. Key words: Angle piece sets; Atamping process; Nesting;Progressive die 目 录 要 III Abstract IV 目 录 V 1 绪 论 1 1.1 课题研究的目的和意义 1 1.2 课题国内外研究概况 1 1.2.1 国外模具发展概况 1 1.2.2 国内模具发展概况 2 1.3 课题研究的主要内容 3 2 冲压工艺设计 4 2.1 冲压件简介 4 2.2 冲压的工