内燃机后油封盖机械加工工艺规程机械CAD图纸设计及系列夹具设计论文.doc

摘 要 本次毕业设计的题目。其主要内容包括的分析、工艺规程设计和专用夹具设计等三大主要部分。 设计专用夹具设计前的工作、总体方案（计算定位误差确定计算夹紧力）、夹具图装配图。工艺规程设计的重点主要是拟定工艺路线和工艺计算。拟定工艺路线要充分考虑实际情况，尽可能的节约生产成本，提高生产率。工艺计算计算工序加工、机床和时间及辅助时间。 关键词：工艺规程设计；专用夹具设计；工艺计算 Abstract The graduation design topic is internal-combustion engine rear oil seal seat. The main contents include the analysis of the components, technical process design and special fixture design, the three main parts. This thesis of parts are analyzed in detail,On the basis of the parts processing requirements analysis,Ultimately determine the blank material, choose the locating datum, and stay out of the appropriate machining allowance. Comprehensive analysis and formulates the components processing technological route. Get process, need to process in the specific parameters are calculated, calculate the machining allowance, cutting parameters, and according to the calculation results the select tool, also calculated during the processing of the auxiliary time. Special jig design main steps have design the preparing work before, overall scheme of the sure (positioning error analysis and calculation and clamping force and the determination of calculation), rendering the assembly drawing fixture and fixture drawing. The focal point of design process regulation is mainly develop process route and process calculation. Process route worked fully consider the actual situation, as far as possible to save the production cost, improve the productivity. Process calculation mainly includes process calculation, machine tool selection and mobile time and auxiliary time calculation. Keywords: Process planning; Special jig design;Machining allowance;Process calculation 目 录 摘 要 III Abstract IV 1 绪论 1 1.1本课题研究的内容及意义 1 1.2国内外的发展概况 1 1.3本课题应达到的要求 1 2 零件的分析 2 2.1 内燃机后油封盖的作用 2 2.2 零件的工艺分析 2 3 内燃机后油封盖工艺规程设计 5 3.1 确定零件生产类型及毛坯的制造形式 5 3.2 零件材料的选择 5 3.3 基准的选择 6 3.2.1 粗基准的选择 6 3.2.2 精基准的选择 7 3.4 拟定工艺路线 7 3.4.1零件各表面加工顺序的确定 7 3.4.2 工序的组合 8 3.4.3 零件工艺路线方案的