支撑板冷冲压工艺及级进模机械CAD图纸设计.doc

摘 要 关键词： Abstract Stamping process analysis mainly consider product stamping forming process, the main is including two aspects of economic and technical content. On the economic front, mainly according to the stamping parts of the production batch, analyzing the product cost, clarify the stamping production can achieve economic benefit; In terms of technology, according to the product drawings, analysis the main parts of structure, size, accuracy requirements and materials performance factors such as whether accord with the requirement of stamping process. Process analysis, therefore, is mainly discussed in does not affect the parts use premise, can make the easiest and most economical way to stamping out. Because the product has no special requirements, so the mold structure with punching and blanking process design, and USES the way of dress design of mould structure, namely the female die is installed in the mould parts. Because the material is not thick, stamping speed faster, discharging discharging using rigid structures. Waste materials and products are used in the die (mould) down. Production batch die blanking pieces for this article using the material. In stamping parts, material costs accounted for more than 60%, the purpose of the layout is reasonable use of raw materials, so the utilization rate of materials is an important factor to decide the product cost, must be calculated carefully, to ensure that the line sheet for reasonable, in order to achieve a better material utilization. Stamping is efficient production mode, adopting the composite die, especially the multi-station progressive die, stamping can be completed in a pressure on the multichannel working procedure, to achieve the pick-up uncoiling, leveling, cutting to the forming and finishing automatic production. High production efficiency, good working conditions production cost is low, general can produce hundreds of pieces per minute. Key words: Stamping process;Layout ;The mould s