- 17
- 0
- 约6.25千字
- 约 19页
- 2016-07-25 发布于浙江
- 举报
;Abstract; There is a growing demand of portable electronics and handheld devices, and miniaturization of power modules becomes highly desirable. However, integrated components such as inductors, transformers, switches and diodes have large and sometime prohibitive parasitic resistance. The integrated inductors and transformers are desired to operate at high frequency to have higher quality factor, but there are a few main difficulties to overcome to switch at high frequency. First, the switching loss begins to dominate, so some form of resonant switching is needed. Second, the reverse reco
您可能关注的文档
- 《4A Isolated Half-Bridge Gate Driver with 4.5V to 18V Output Drive Voltage》.pptx
- 《A 2.5kV isolation 35kVus CMR 250Mbps 0.13mAMbps Digital Isolator in Standard CMOS with an on-chip small transformer》.ppt
- 《A 20MHz Switched-Current Sample-and-Hold Circuit for Current Mode Analog Iterative Decoders》.pptx
- 《A CMOS interdigital capacitive humidity sensor with polysilicon heaters》.pptx
- 《A Fully Integrated Linear CMOS Power Amplifier with High Output Power and Dynamic Range for WiMAX Application》.pptx
- 《A transient-enhanced NMOS low dropout voltage regulator with parallel feedback compensation》.pptx
- 《A Two-Stage Broadband Fully Integrated CMOS Linear Power Amplifier for LTE Applications》.pptx
- 《A UVLO Circuit in SiC Compatible With Power MOSFET Integration》.pptx
- 《Analysis of Feedback in Converter using Coreless Printed Circuit Board Transformer》.ppt
- 《Analysis of the coreless transformer in wireless battery vehicle charger》.ppt
原创力文档

文档评论(0)