Telescope汇总.ppt

WIRTH_Pr?s_00.01 WIRTH Group – Telescope Shield Overcut – Changing cutters WIRTH Group – Telescope Shield TECHNICAL SPECIFICATION, TB 570 E/TS Machine model TB 619 E/TS Type Telescope Shield Bore diameter 6,19 mm Total installed power 2790 kW Total weight of basic TBM approx 450 t Weight of back-up 1-stroke approx. 250 t Length of TBM, face to end of tail approx.12,5 m Length of TBM with back-up 1-stroke approx.130 m ? Cutter head: Bore diameter with new discs: 6,19 m Bore diameter with max. wear of gauge cutters: 6,16 m Over cut for gauge cutters, change 50 mm in radius Over cut standard at crown 55 mm at invert 15 mm Nominal spacing: 80 mm approximately No. of cutters per track: 1 centre and face 2 pre gauge track 3 gauge track Reamer cutters 1 unit Nozzles approx. 19+ 1x EDZ, WIRTH Group – Telescope Shield Cutter head drive Power: 6 X2 86 1716 kW Drive type: infinite variable Frequency Drive Rotational speed: 0-7,8 RPM Torque at 3,9 rpm 50 Hz : 4000 kNm Torque at 7,8 rpm 66 Hz .: 2000 kNm nominal speed Break out torque 5200 kNm Telescope Section No. of telescope cylinders 14 Max. thrust 490 bar 25,000 kN Cylinder stroke Segment 1,5 m 1,650 mm Operating pressure 490 bar ? Gripper Shield No. of cylinders 2 Total effective gripper force 45,000 kN Ground pressure 4 MPa. ? Rear shield Total pushing force 34,000 kN WIRTH Group – Telescope Shield Cutter Type back loaded Cutter diameter: 432 mm Number of cutters: Centre 6 face 36 gauge 3 nominal load 250 kN Number of reamers: 1 Kerf spacing: approx. 80mm Cutter bearing: taper roller bearing, 2 units Sealing: two-ring friction seal steel Lubrication: oil with additives Equipment for changing cutter: 1 unit for centre cutter 1 unit for face and gauge cutter All cutter types back-loading version. Belt Conveyor of TBMBelt width: 800 mm Carrying capacity: 700 m3/h Running speed: 0 – 2,5 m/sec. ? Machine hydraulic