S3310、S3710吊装计算.docVIP

1. 工程概述 General of the work 合成车间四楼有 2 台干燥机，位号为 S3310,S3710 ，此 2 台设备外形尺寸大，重量重，分散到货，要求现场组装，设备最重部分为干燥机本体，重量为10吨，吊装难度大，为了安全稳妥的吊装设备，在此对S3310、S3710的吊装作以补充计算；安装作业在意大利专家的指导下进行，其它要求参照原施工方案。 There are two sets of dryers S3310 and S3710 on the fourth floor of synthesis building. These two equipment have large sizes and heavy height; and they are delivered to the site separately, and they should be assembled at site. The heaviest part of the equipment is the body of dryer, which is 10 tons heavy. So it is difficult to lift these equipment. In order to lift the equipment safely and stably, we make this additional account herein. The erection will be performed under the direction of the expert from Italy, and the other requirements will be taken according to the origin construction scheme. 2. 编制依据 Bases for compiling 2.1 业主或制造厂提供的设备安装图； Installation drawings of the equipment supplied by the client or the manufacturer; 2.2 《中低压化工设备施工及验收规范》 HGJ209-83 ； “Code for construction and acceptance of chemical processing equipment with medium or low pressure” HGJ209-83; 2.3 《化工工程建设起重施工规范》 HGJ201－83 ； “Code for lifting in chemical engineering construction” HGJ201-83 2.4 《炼油化工施工安全规程》 SH3505－99 ； “Safety rules for chemical engineering construction of oil refining” SH3505-99 2.5吊车性能表。 Performance table of the crane 3.吊装方法 Lifting method 设备 S3310 ， S3710 采用 T80 汽车吊分别站在厂房的东,西侧从厂房顶部预留孔中吊装就位； The equipment S3310 and S3710 will be lifted separately to their positions through the top of the building with the crane of 80T standing on the east side and west side of the building. 4.S3310,S3710 吊装抗杆核算 Arm resistance of the crane while lifting the equipment S3310 and S3710 查吊车性能表， T80 汽车吊在杆长 40M,回转半径 10M能吊 12.6吨，吊装示意图附后。 After checking the performance table of crane, the crane of 80T can load 12.6 tons when its arm is 40 meters and the turning radius is 10 meters. See the attached diagram about lifting ⑴吊车臂杆与厂房抗杆核算 Account about the resistance between the arm of the crane and the building H L2- R2