VACUUM WATER ABSORBING MACHINE吸尘吸水机.docVIP

Operation procedure操作程序 Insert the electricity plug into the socket. 电源插头插入带接地线的插座上；Take the vacuum belt out of the dirty water tank将机内污水箱中的真空带取出；Pour the defoamer into the dirt water tank; 向污水箱内注入消泡剂； Gently tread the footboard forwards, make the high speed water absorbing brush fall down to touch the floor. 轻轻向前踏下踏板，使高速吸水刷落下与地板接触；Closes the switch, impels water absorbing /vacuuming machine start to absorb water with a high speed. 合上开关，推动吸水/吸尘机，高速吸水刷开始前后吸水；End the water absorbing work, and cut off the electricity power. 结束吸水，切断电源；Gently step the footboard downward, make the high effective absorbing brush raise, and make the water/dust vacuum machine enter the walking state. 轻轻向下踏下踏板，使高效吸刷升起，吸水/吸尘机进入行走状态；It also can connect the adequate appendix tools with the soft vacuum pipe, use the appendix tools to absorb water. 也可将适用的附属工具接到真空软管上，用附属工具吸水；Move the water/dust absorbing machine into the waterspout. 将吸水/吸尘机推到排水口；Take down the drainpipe; turn on the stem of the pipe to drain. Lift the drainpipe can stop the drainage. 取下排水管，拧开排水管堵头，排水。提起排水管，即可停止排水；After empty the dirt water tank, open the top cover of the machine, and clean it by clean water so as not to produce odor smell. 污水箱排空后，打开机器上盖，用清水冲洗，以免产生异味；Turn off the stem, make the drainpipe reposition. 拧上堵头，排水管复位。 The operation process of the vacuum machine. 吸尘操作过程nsert the source plug into joint grounding plug; 电源插头插入带接地线的插座上；Puts in the vacuum-bag; 放入真空袋； Put the filtration bag inside of the contamination box, and check the brim as well as the mouth of the box is sealed tightly. 在污物箱（吸水时称污水箱）内放置过滤袋。检查过滤袋边缘和污物箱口是否密封；lose the top cover and tighten the bolt. 合上上盖，上紧插销；onnect the vacuum hose and the attached tool adequately; 连接好真空软管和附属工具；It can also put down the high effective absorbing brush to absorb the grains such as the dust, sand, and sawdust也可放下高效吸刷，用于吸细小颗粒（灰尘、沙子、锯末等）；Closes the switch, starts to vacuum; 合上开关，开始吸尘； Regularly check whether the vacuum-bag contains the sundries fully, and promptly replaces the vacu