hcu_all.ppt

Analog Input Module IMASI23 The Configuration of Termination Unit NTAI06 Analog Input Module IMASI23 The Configuration of Termination Unit NTAI06 Analog Input Module IMFEC12 The Configuration of Termination Unit NTAI05 Analog Input Module IMFEC12 Analog Input Module IMFEC12 Analog Output Module IMASO11 Analog Output Module IMASO11 Module Address Dipswitch (S1) Analog Output Module IMASO11 Analog Output Module IMASO11 The Configuration of Termination Unit NTDI01 Analog Output Module IMASO11 The Configuration of Termination Unit NTDI01 Analog Output Module IMASO11 The Terminal Assignments of Termination Unit NTDI01 Analog Output Module IMASO11 Cable Connections Setup and Physical Installation The ASO module can have one of 64 addresses (address 0 through 63) on the I/O expander bus. This address uniquely identifies the I/O module to the control module and must be the same as the address set in the control module configuration (FC 149 specification S1). Analog Output Jumpers (J1 through J28) Jumpers J1 through J28 configure the analog output mode (current or voltage) for outputs one through 14. Current mode is 4 to 20 milliamperes; voltage mode is 1 to 5 VDC. Figure 3-1 shows the jumper locations on the ASO board. Determine the output mode requirements for each analog output for each application; set jumpers to the positions shown in Table 3-2. 系统介绍：数字输入子模件 Digital Input Slave Module IMDSI22/13/14模件具有的Input通道： DSI TDI KTU ? 通道数量：16个可分别组态的DI通道 ? 通道性质：电压：24、48、125VDC 120VAC 电流：4.5、5.5、4.7、4.8mA ? 使用设备：NKTU01、NTDI01 ? 型号分类：DSI22：24/48/125VDC 120VAC DSI13：24VDC DSI14：48VDC ? 使用功能码：FC84X2 系统介绍：数字输入子模件 Digital Input Slave Module IMDSI22/13/14模件的方框图 阀值检测 系统介绍：数字输入子模件 Digital Input Slave Module DSI模件的结构 系统介绍：数字输入子模件 Digital Input Slave Module IMDSI22/13/14模件的LED