FreescaleKEA12832位MCUCAN和马达控制方案.docxVIP

Freescale KEA128 32位MCU CAN和马达控制方案关键字：工业控制,马达控制,BLDC,PMSMFreescale公司的Kinetis EA系列MCU是基于ARM的可升级低功耗的32位MCU,采用高达48MHz ARM Cortex-M0+内核,具有单周期32位X32位的乘法器,工作电压2.7V-5.5V,闪存写电压范围2.7V-5.5V,工作温度-40 到125℃,主要用在汽车电子如HVAC,门窗和座位控制,环境灯控制,TPMS以及马达控制等.本文介绍了Kinetis EA系列MCU主要特性,框图, 以及用于CAN和BLDC/PMSM马达控制的TRK-KEA128开发平台主要特性,电路图和材料清单.Kinetis EA series MCUs for automotive provide an automotive-grade, scalable, 32-bit portfolio with a broad ARM ecosystem for a wide range of automotive applications. The EA series is pin compatible with Freescale’s 8-bit S08RN family and include a powerful array of analog, communication and timing and control peripherals with specific Flash memory size and pin counts. This MCU series offers low-power, built on the ARM?-Cortex? M0+ core, high-robustness and cost-efficiency to provide automotive developers with an optimized ARM-based solution. This series was designed with EMC/ESD in mind to ensure strong noise immunity and low radiated emissions.KEA128主要特性:? Operating characteristics– Voltage range: 2.7 to 5.5 V– Flash write voltage range: 2.7 to 5.5 V– Temperature range (ambient): -40 to 125℃? Performance– Up to 48 MHz ARMR Cortex-M0+ core– Single cycle 32-bit x 32-bit multiplier– Single cycle I/O access port? Memories and memory interfaces– Up to 128 KB flash– Up to 16 KB RAM? Clocks– Oscillator (OSC) - supports 32.768 kHz crystal or 4 MHz to 24 MHz crystal or ceramic resonator; choice of low power or high gain oscillators– Internal clock source (ICS) - internal FLL with internal or external reference, 37.5 kHz pretrimmed internal reference for 48 MHz system clock– Internal 1 kHz low-power oscillator (LPO)? System peripherals– Power management module (PMC) with three power modes: Run, Wait, Stop– Low-voltage detection (LVD) with reset or interrupt, selectable trip points– Watchdog with independent clock source (WDOG)– Programmable cyclic redundancy check module (CRC)– Serial wire debug interface (SWD)– Aliased SRAM bitband region (BIT-BAND)– Bit manipulation