MASTER后处理NO TOOL.docVIP

# Post Name : MPFAN # Product : MILL # Machine Name : GENERIC FANUC # Control Name : GENERIC FANUC # Description : GENERIC FANUC MILL POST # Associated Post : NONE # Mill/Turn : NO # 4-axis/Axis subs. : NO # 5-axis : NO # Executable : MP 7.20 # # WARNING: THIS POST IS GENERIC AND IS INTENDED FOR MODIFICATION TO # THE MACHINE TOOL REQUIREMENTS AND PERSONAL PREFERENCE. # # -------------------------------------------------------------------------- # Revision log: # -------------------------------------------------------------------------- # Programmers Note: # CNC 02/12/98 - Initial post setup, jph # CNC 03/25/98 - Add inverse feed, correct DPM feed, jph # CNC 05/27/98 - Modifed pwcs calls to stop repeated output, jph # CNC 09/03/98 - fixed modality problem with index = 0 in pfcout, grt # CNC 10/22/98 - Added a check for opcode = 3 to the logic test in pfcalc, jce # CNC 10/26/98 - Added force_wcs switch for Non-Modal WCS output, grt # CNC 12/14/98 - Added bldnxtool and comment to stagetool, grt # CNC 12/16/98 - Changed sgplane to *sgplane in psof, grt # CNC 12/21/98 - Modified stagetool output, and added more index options. # You can set index to 0 - 3, and ctable will now test for # fractional values and assign an appropriate format. I also # added a lock_table switch, and made dwell modal within all # drill cycles, grt # CNC 02/08/98 - Added ftrnd to logic in pindex. jce # CNC 02/17/99 - Removed Index #4 option and hi_lim_c, grt # CNC 03/02/99 - Added logic to pdrill0 to support wcs change, and # turned off nobrk in null toolchanges for wcs, grt # # -------------------------------------------------------------------------- # Features: # -------------------------------------------------------------------------- # This post supports Generic Fanuc code output for 3 and 4 axis milling. # It is designed to support feat