毕业设计（论文）-基于ARM短消息发送程序设计.doc

摘 要 本课题研究的是以S3C2440 ARM9为控制核心，通过编程实现对无线模块MC35的控制，从而实现短消息的发送。该课题主要由S3C2440控制模块、无线模块MC35、LCD显示、存储器和触屏等部分组成。该系统通过程序设计，使液晶显示器显示信息，然后通过触屏进行操作，最后通过MC35模块将短消息发送出去。 对于该课题的研究主要是在软件这块，即短消息发送程序设计这部分。在此，我采用的短消息发送程序设计的设计方案是使用带操作系统的ARM9来控制MC35模块。这样有更好的人机界面，便于操作。大概的程序设计编写流程主要可以分为这样两个部分：一、PDU协议代码的编辑；二、程序的设计与编写。PDU协议代码的检测是将超级终端与MC35模块相连后，在超级终端中完成的。主要程序的编写与调试是在ADS1.2集成开发环境下进行的。 最后，通过技术设计可行性分析、论证，根据课题要求进行调试和校正，使该基于ARM短消息发送程序设计能正确的通过触屏按钮将短消息发送出去。 关键词：MC35模块 短消息 PDU协议 ADS1.2集成开发环境 Abstract The study of the subject is S3C2440 ARM9 as the control center,Through programming control of the wireless module MC35 to achieve the short message sending. Mainly by S3C2440 control module, the wireless module MC35,LCD display, memory and touch screen and other components. The LCD display information by system programming.And then operate via touch screen,finally through the MC35 module will send a short message. For research on the subject mainly is about software, short message sending program design this part. Here,the option I chosed is ARM9 with the operating system to control the MC35 module. Like this,it will have a better man-machine interface and will easy to operate. Write about the program design process can be divided into two part: A, PDU protocol code’s editing; B, the program design and preparation.PDU protocol code is detected by Super Terminal with the MC35 module is connected to it. Programming and debugging the main program is carried out under the ADS1.2 integrated development environment. Finally,through technical design feasibility analysis and demonstration,and according to the requirements of the subject to debug and correct,then the ARM-based program designed to send short messages can send out the messages correctly by via touch-screen button. Key words: MC35 Module Short Message PDU Protocol ADS1.2 Integrated Development Environment 目 录 摘要 I Abstract II 绪论 1 1 系统介绍 3 2 硬件部分介绍 5 2.1 ARM9开发板 5 2.2 MC35模块 6 2.3 显示器 7 2.4 存储器