36.133-3符号.docVIP

3.2 Symbols For the purposes of the present document, the following symbols apply: […] Values included in square bracket must be considered for further studies, because it means that a decision about that value was not taken. 包含在方括号里的值是有待进一步研究的，它的意思是关于这个值的结果未被接受 BWChannel Channel bandwidth, defined in TS 36.101 subclause 3.2 CPICH_Ec Average energy per PN chip for the CPICH 普通导频信道的每个PNchip的平均能量 CPICH_Ec/Io The ratio of the received energy per PN chip for the CPICH to the total received power spectral density at the UE antenna connector. 普通导频信道的每个PNchip的接收到的能量与UE天线连接器处接收到的所有功率谱密度的比值 Ec Average energy per PN chip. 每个PNchip的平均能量 ês Received energy per RE power normalized to the subcarrier spacing during the useful part of the symbol, i.e. excluding the cyclic prefix, at the UE antenna connector 在符号的有用部分上每个RE（功率归一化至子载波间隔上）接收的能量。也就是：在UE天线连接器处包括循环前缀 Io The total received power density, including signal and interference, as measured at the UE antenna connector. 所有接收到的功率谱密度，包括信号和干扰，在UE天线连接器处测量 Ioc The power spectral density integrated in a noise bandwidth equal to the chip rate and normalized to the chip rate of a band limited noise source simulating interference from cells, which are not defined in a test procedure as measured at the UE antenna connector. 有限带宽内的噪声源（小区的模拟干扰，在测试过程中没有被定义）功率谱密度（整合在噪声带宽内，等于chip速率并归一化为chip速率），在UE天线连接器处测量 Iot The received power spectral density of the total noise and interference for a certain RE power integrated over the RE and normalized to the subcarrier spacing as measured at the UE antenna connector 一个确定RE（功率整合在RE上，并且归一化为子载波间隔）的整个噪声和干扰的接收到的功率谱密度，在UE天线连接器处测量 The power spectral density of a white noise source average power per RE normalised to the subcarrier spacing , simulating interference from cells that are not defined in a test procedure, as measured at the UE antenna connector 一个白噪声源的功率谱密度（每个归一化至子载波间隔的RE的平均功率），来自小区的模拟干扰，在测试过程中没有被定义，在UE天线连接器处测量 S Defined in TS 36.304, subclause 5.2.3.2 for E-UTRAN 小区搜索标准S满足： Where: Where: 信号值 Q