Procedures of partial electric discharging test.docVIP

250A 肘型插头的局部放电试验 Partial discharging test of 250A elbow plug 挂好接地线。 Hang earthing wire in right position 检查设备的连线： AC-2000 工频高电压试验控制台---TDYZ-300/0.38 柱式调压器---YDTW300/300五局试验变压器---GR3000-1/5 工频带保护电阻---工频电容分压器---局部放电检测阻抗3号）——局部放电检测仪。且必须做好各设备的接地 Check connecting wires of the following instruments: AC-2000 high voltage test cotrolling booth---TDYZ-300/0.38 voltage monitoring machine in pillar shape---YDTW300/300 testing transformer---GR300-1/5 AC protective electric resistance---voltage distributing machine for AC electric capacity---NO. 3 partial discharging test resistance---partial discharing testing machines. Earthing job is required to be done well for the above-mentioned instruments. 把安装好插头的电缆放在绝缘试验架上，然后从耦合电容分压器（工频电容分压器）顶端引出高压线与电缆一端相连接。 put cable with plug into insulating test rack, and then connect the top of voltage distributing machine for AC electric capacity to the end of cable with wire. 肘型插头上的屏蔽抱箍与接地线相连接，绝缘试验架与接地线相连接。 Connect elbow screened holder with earthing wire, connect insulating test rack with earthing wire. 先把方波检验仪发生器接地端接地，高压端接电容分压器并且把电容连调到40PC Connecting square wave checking instrument with earthinng wire, high voltage end with voltage distributing machine for electric capacity and monitoring electirc capacity to 40PC. 取下接地棒 Take off the earthing band 打开总电源 Turn on the main electric power 打开局放仪电源，点击“开始校验”，输入检验值：50PC.选择合适的档位，并且根据大小差距调整粗调开关及细调开关，及检测仪的频率范围。 Turn on the electric power of discharging instrument, click the key of “begin check”, write in checking number：50PC. Select proper position, and monitor coarse controling switchgears, fine controlling switchgears and rating range of monitoring instruments according to the discrepancy. 调整到与设定值相同时，点击“校验完成” After monitoring the number to preseting number, click the key of “finish checking” 挂好接地棒，取下校正电量发生器高压端，再取下方波检验仪发生器接地端。 Hang the earthing band well, take off the high voltage end of electric flow monitor, and take off the earthing end of square wave checking instrument. 取下接地棒 Take off the e