BAK EXAM 1.docVIP

Compared to a low camber wing , a high camber wing will produce ： less lift and less drag less lift and more drag more lift and less drag more life and more drag The function of trim tabs is to ： A} improve stability B) lower the stalling speed C) remove control column forces D) relieve control column forces 3 The angle of attack of an aerofoil can be described as the angle between the：： A) leading edge and the line parallel to the pitching axis B) wing chord and horizontal plane C) relative airflow an chordline D) relative airflow and upper surface of the wing 4 One term used to describe the angle between the wing spar and the lateral axis of an aeroplane is： A) dihedral B) taper C) sweepback D) washout 5 Stalling speed is increased by an increase in ： A) altitude B) air density C) angle of attack D) gross weight 6 If other factors remain constant , increasing the thickness or _________ A) lower lift and higher drag B) lower lift and lower drag C) higher lift and lower drag D) higher lift and higher drag 7 If all other factors remain constant ,as the angle of attack is increased , lift will ： A) increase until the stalling angel is angle is reached B) increase until the maximum lift/drag angle is reached, then decreased C) decrease until the minimum lift angle is reached, then increases D) decrease until zero angle of attack is reached, then increase 8 The angle between the wing spar and the horizontal plane is called the : A) dihedral angle B) angle of incidence C) angle of attack D) camber angle 9 Engine cooling during a climb can be improved by : A) increasing the RPM B) flying at a larger angle of attack C) using a higher IAS D) leaning the mixture 10 Aviation fuel that does not contain coloured dye should only be used in : A) turbine engines B) fuel injected C) turbo charged engines D) engines fitted with automatic mixture control 11 During take-off, a tachometer reading higher than specified in the Flight Manual indicates that :