螺纹+公制和PG制.docVIP

公制螺纹接头内径与软管内径对照表 Comparison table for inside diameter, connector with metric threads to inside diameter, conduits 软管CONDUIT 公制螺纹管接头 CONNECTOR WITH METRIC THREAD 标称内径 nominal width NW 内径 Inside ? nominal 螺纹规格 Thread size 内径 Inside diameter mm (nom.) ID 标准 standard 公制metric 金属螺纹 metal thread 聚酰胺螺纹polyamide thread 07 10 6.2 M10 - - 10 12 9.6 M12 5.7 8.0 10 12 9.6 M16 - 11.0 12 16 12.0 M16 9.7 11.0 17 20 16.2 M20 13.7 14.6 23 25 22.6 M25 18.6 19.0 29 32 29.0 M32 25.7 26.0 36 40 36.5 M40 33.4 32.0 48 50 47.5 M50 42.7 42.0 48 50 47.5 M63 54.0 53.0 PG 螺纹接头内径与软管内径对照表 Comparison table for inside diameter, connector with PG threads to inside diameter, conduits 软管CONDUIT PG制螺纹管接头 CONNECTOR WITH PG THREAD 标称内径nominal width NW 内径 Inside ? nominal 螺纹规格 内径 Inside diameter mm (nom.) ID 标准 standard 公制metric Thread size 金属螺纹metal thread 聚酰胺螺纹polyamide thread 07 10 6.2 PG07 - 8.0 10 12 9.6 PG09 9.5 10.0 12 16 12.0 PG11 12.5 13.0 - - - PG13.5 14.5 14.5 17 20 16.2 PG16 16.5 17.5 23 25 22.6 PG21 22.5 22.5 29 32 29.0 PG29 30.5 30.5 36 40 36.5 PG36 40.5 37.5 - - - PG42 - 48.0 48 50 47.5 PG48 52.0 50.0 适用于PMA接头扭矩 Torques for PMA connector PMA 接头螺纹推荐扭矩 / Recommended torques for the PMA connector thread 对带螺纹孔的开口 / For threaded bore holes 带螺母 / With lock nuts * 螺纹组合：金属＋金属 / Thread combination: metal + metal ** 螺纹组合：金属＋聚酰胺或聚酰胺＋聚酰胺 / Thread combination: metal + polyamide or polyamide + polyamide 注意：以上数据为近似值。在实际应用中请考虑螺纹的影响。The dates are approximate values. At application please take into account the influence of the counter-thread. 接头带消除应力设计 / Connector to achieve strain relief 当设计和指定安装两个连接点时，以下尺寸应要计算在内。 在每个管接头内的插入长度要额外计算，请参照下表。 The following dimensions have to be taken into account if designing and specifying a certain length between two connecting points. The p