ABAQUS如何画XY曲线图1.docVIP

D.10.2?Customizing an X–Y plot By default, Abaqus computes the range of the X- and Y-axes from the minimum and maximum values found in the data read from the output database. Abaqus divides each axis into intervals and displays the appropriate major and minor tick marks. The Axis Options allow you to set the range of each axis and to customize the appearance of the axes; the Curve Options allow you to customize the appearance of the individual curves; the Chart Options and Chart Legend Options allow you to position the grid and legend, respectively. X–Y plot customization options apply only to the current viewport and are not saved between sessions. (这部分讲的主要是对曲线图进行相关的操作,这些操作主要包括:设置坐标轴的名称,单位;调整图域的大小;设置刻度线的长度,数量;是否显示栅格,是否有标题栏.自已摸索一下就OK了,也可以跳过不看) To customize an X–Y plot: From the main menu bar, select OptionsXY OptionsAxis (or click in the prompt area to cancel the current procedure, if necessary, and double-click either axis in the viewport). Abaqus displays the Axis Options dialog box. Switch to the Scale tabbed page, if it is not already selected. Specify that the X-axis should extend from 0 (the X-axis minimum) to 20 (the X-axis maximum) and that the Y-axis should extend from –200 (the Y-axis minimum) to 0 (the Y-axis maximum). Tip:? Select each axis in turn in the Axis Options dialog box, and then edit the scale as noted above. From the options in the Axis Options dialog box, do the following. In the Scale tabbed page, request that major tick marks appear on the X-axis at four-second increments (select By increment in the Tick Mode region of the page). Request 3 minor tick marks per increment along the X-axis (this corresponds to a minor tick mark every second) and 4 minor tick marks per increment along the Y-axis (this corresponds to a minor tick mark every 10 mm). In the Title tabbed page, type a Y-axis title of Displacement U2 (mm). In the Axes tabbed page, request a Decimal format with zero decimal places for the Y-axis labels. Click Dismiss to close the A