检验大纲.doc

检 验 大 纲 EXAMINATION PROGRAM 文件编号 Doc. No. 产品名称 Job Name 产品图号/版号 Job Dwg.No./Rev. 产品编号 Job No. 序号 No. 检查项目 Item 合格标准 Acceptable Standard 备注 Remarks 1 材料到货检验 Material receiving examination 1材料标记检查。 Inspection of material identification; 2材料表面和切割边缘无缺陷。 No defect on material surface and cutting edge; 3包括厚度在内的尺寸测量。 Dimension measuring including thickness; 2 领料核实、划线、标记移植检查 Verification of material issuance and inspection of lay-out, mark transference 检验使用的材料应带有标记或标牌,且与图样相符；材料牌号：SA-516Cr70，筒体厚10mm，展开长度3173mm，封头：厚度10mm，展开直径1250mm； 认定标志移植的正确性。 Make sure that the used material should have identification or mark, and should be in accordance with the drawing; Material type: SA-516 Cr70;Shell thickness:10mm; Spread length: 3173mm; Head thickness:16mm; Spread diameter:1250mm; Make sure that the mark transfer is correct. 3 封头成型检验 Inspection of head forming 测量封头直边不圆度≤10mm，内表面形状偏差+12.5mm/-6.25mm,封头最小厚度8.5mm。 Measuring out-of-round for the head straight skirt ≤10mm; Inside shape deviation +12.5mm/-6.25mm; Minimum head thickness: 8.5mm. 4 坡口检查 Groove inspection 封头坡口：内坡口30°±2.5°，钝边2±1mm； Head groove: Inside groove 30°±2.5°, Size of root face: 2±1mm；Shell groove: 筒体与封头对接：内坡口30°±2.5°，钝边2±1mm； Butt joint of shell to head: Inside groove: 30°±2.5°, Size of root face: 2±1mm；30°±2.5°°，钝边2±1mm；接管与法兰对接坡口：外坡口37.5°±2.5°，钝边 2±1mm；筒体上接管开孔坡口: 外坡口50°±5°，钝边 1±1mm。 Grooves of longitudinal of shell: Inside groove: 30°±2.5°, Size of root face: 2±1mm；Groove of joint between nozzle and flange: Outside groove: 30°±2.5°, Size of root face 2±1mm Opening for connector on shell: Outside groove: 50°±5°，Size of root face 1±1mm 5 滚圆检验 Inspection of rolling: 筒体不圆度≤10mm。 Out-of-round for shell: ≤10mm. 6 组对检验 Fitting Inspection 筒体对接纵焊缝及筒体与封头对焊环焊缝组对间隙2±1mm。 The clearance between the longitudinal and of shell as well as the circumferential welding between shell to head: 2±1mm. 接管与法兰及接管与筒体组对间隙2±1mm。 The clearance of the joint between nozzle and flange as well as the joint between nozzle and shell: 2±1mm