14-Ruston TB5400.pptVIP

What is TB5400 Gas Turbine Ruston gas turbine is twin shaft unit and comprise two main section: 1. The gas generator, 2. Power turbine 1.The gas generator: a). The air inlet casing; b). Compressor stator casing; c). Compressor rotor; d). Compressor turbine stator casing; e). Compressor turbine rotor; f). Center casing; g). Combustion chamber. 2. Power turbine: a). The power turbine stator assembly; b). Exhaust collector assembly; c). Power turbine rotor; d). Driven reduction gearbox. Ruston TB5400 Gas generator( gas turbine) Air inlet casing: a). Air inlet ducting; b). Variable inlet guide vanes(26ea vanes): It is operated by an relay valve in which P2(52psi) comes from stage 10 of compressor to drive the air relay valve, while engine reaches approximately one third of full load(1250KW), the IGV will be automatically pushed to running position, therefore giving maximum mass air flow to gas generator and resulting in a reduced maximum temperature at max. load. Compressor Rotor and stator 1. Compressor rotor equips twelve stages of stator blades and one stage of inlet guide vanes. 2. To prevent compressor surge during starting and to limit the degree of over speed when load is shed, it is necessary to reduce the compressor delivery pressure, so compressor stator fitted two blow off valves with spring loaded and located between stator stages six seven, four blow off valves are fitted on the rear of centre casing, but without spring equipped. CT and PT rotor stator 1.CT and PT rotor consists of two stages and stator has two stages as well. 2.CT and gas generator has the same speed, 100% full speed is 10,000rpm, Max is 105 and overspeed set point is 110%+3%. but PT speed is lower than CT speed, full speed is 7950rpm, overspeed set point is the same as above. 3.There are 16 thermocouples fitted on the exhaust of PT, even number of thermocouple feeds signal to governor, but odd number of thermocouple feed signal to temperature monitor. In additional, 2 extra ther