Allegro DRC 错误代码.doc

Allegro DRC 錯誤代碼 代码 相关对象 说明 单一字符代码 L Line 走线 P Pin 元件脚 V Via 贯穿孔 K Keep in/out 允许区域/禁止区域 C Component 元件层级 E Electrical Constraint 电气约束 J T-Junction 呈现T形的走线 I Island Form 被Pin或Via围成的负片孤铜 错误代码前置码说明 W Wire 与走线相关的错误 D Design 与整个电路板相关的错误 M Soldemask 与防焊层相关的错误 错误代码后置码说明 S Shape/Stub 与走线层的Shape或分支相关的错误 N NotAllowed 与不允许的设置相关的错误 W Width 与宽度相关的错误 双字符错误代码 BB Bondpad to Bondpad Bondpad之间的错误 BL Bondpad to Line Bondpad与Line之间的错误 BS Bondpad to Shape Bondpad与Shape 之间的错误 CC Package to Package Package之间的 Spacing 错误 Symbol Soldermask to Symbol Soldermask零件防焊层之间的Spacing 错误 DF Differential Pair Length Tolerance 差分对走线的长度误差过长 Differential Pair Primary Max Separation 差分对走线的主要距离太大 Differential Pair Secondary Max Separation 差分对走线的次要距离太大 Differential Pair Secondary Max Length 差分对走线的次要距离长度过长 DI Design Constraint Negative Plane Island 负片孤铜的错误 ED Propagation-Delay 走线的长度错误 Relative-Propagation-Delay 走线的等长错误 EL Max Exposed Length 走线在外层（TOPBOTTOM）的长度过长 EP Max Net Parallelism Length-Distance Pair 已超过Net之间的平行长度 ES Max Stub Length 走线的分支过长 ET Electrical Topology 走线连接方式的错误 EV Max Via Count 已超过走线使用的VIA的最大数目 EX Max Crosstalk 已超过Crosstalk值 Max Peak Crosstalk 已超过Peak Crosstalk值 HH Hold to Hold Spacing 钻孔之间的距离太近 HW Diagonal Wire to Hold Spacing 斜线与钻孔之间的距离太近 Hold to Orthogonal Wire Spacing 钻孔与垂直/水平线之间的距离太近 IM Impedance Constraint 走线的阻抗值错误 JN T Junction Not Allowed 走线呈T形的错误 KB Route Keepin to Bondpad Bondpad在Keepin之外 Route keepoutto Bondpad Bondpad在keepout之内 Via KeepouttoBondpad Bondpad在Via Keepout之内 KC Package to Place Keepin Spacing 元件在Place Keepin之外 Package to Place Keepout Spacing 元件在Place Keepout之内 KL Line to Route Keepin Spacing 走线在Route Keepin之外 Line to Route Keepout Spacing 走线在Route Keepout之内 KS Shape to Route Keepin Spacing Shape在Route Keepin之外 Shape to Route Keepout Spacing Shape在Route Keepout之内 KV BBVia to Route Keepin Spacing BBVia在Route Keepin之外 BBVia to Ro