环氧磷酸锌底漆的用途.doc

Intended Uses 用途 多用涂喷涂底漆，低温固化，复涂时间短，不受复涂时间限制可被各种高性能面漆复涂， 用于防护喷砂处理的钢材，不论湿喷砂或干喷砂均可。 Spray primer with widely uses. Curing at low temperture. Short overcoating time. Not limited by Over coating time. Overcoating with high performance finish. Applied for protecting steel whether by dry blast or by wet blast. Product Information产品简介 二罐装，磷酸锌环氧树脂底漆，耐搬运和运输过程的损伤特性，固化温度低至0℃。 Two packages, Zinc phoshate epoxy resin primer. Resistance to the possible damage during transportation. Curing temperature is low to 0℃。 Application details 产品数据 Volume Solids 固体份 ≥65% Dry Flm Thickness干膜厚度 75microns equivalent to 115 microns of wet film 75微米相当于115微米湿膜厚 Theoretical Coverage 理论涂布率 6.1m2 /Kg at the stipulated volume solids and 75microns of dry film thickness 6.1平方米/公斤，以规定体积固体份和75微米干膜厚计 Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Storage and Handling 施工详述 Mix Radio 混合比 A : B 6:1 by weight 甲:乙 6:1 Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Adoptable 适用 Conwentional Spray 传统喷涂 Not adoptable 不适用 Thinner 稀释剂 SC003 Cleaner 油漆设备清洗剂 SC003 Pot Life 使用期 5℃:6h 23℃:2.5h Storage 贮存期 One year 一年 Drying time 干燥时间 Substrate Temperature底材温度 Touch Dry 表干 （min） Hard Dry 硬干 h） Over coating Interval 覆涂间隔 Min最短 Max最长 5℃ 23℃ 35℃ 102 45 30 24 6 4 10hours小时 3hours小时 2hours小时 14days 天 Storageand Handling 贮存与管理 Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 A;24Kg in 20 liter container 甲:24公斤装于20公升容器中 B:4Kg in 4 liter container 乙:4公斤装于4公升容器中 Flash Point 闪点 ≥23℃ 高于23℃ Specific Gravity 比重 Approx 1.42Kg/L 大约1.42公斤/公升 Specification and Surface preparation 技术要求及表面处理 Clean and remove grease according to SSPC-SPI solvent cleaning. Remove the weld spatters, smooth weld seams or sharp edges. The surface to be painted must be dry and clean. Blast clean to Swedish SISO55900 Sa2.5. Try to smooth, fill or properly treat the surface blemishes come from blasing. Precoated primer steel: Electro-welding joint or damag