led路标.docVIP

24V rechargeable 800AH or similar capacity battery pack 用在 temporary LED road signs at remote country areas 两种可能的离网构建 : a No solar no wind turbine, standalone, charge at workship, discharge at out-door application expected 2 weeks operation 无太阳能，无风能，独立系统，在工作站充电，户外放电，可以连续工作2个礼拜 b 160W solar + 400W micro wind turbine assisted, charge at workshop, out-door application expected 4 weeks operation.160瓦太阳能和400瓦风能涡轮机动力系统，工作站充电，户外连续放电工作4个礼拜。 - Rated power of the LED road signs: 62W - Normal working current of LED road signs: 2.5A - Normal working voltage of LED road signs : 24V - Maximum working current of LED road signs:3.5A - Expected working time of the battery pack for LED road signs on single charge: 14 * 24 hours 336 hours预期的电池工作时间 - Maximum dimensions for the battery pack if there is a restriction: No restriction对电池尺寸无要求 - How would you like the battery to be packaged,does it need a hard case? Not a necessary feature, - Does the battery need any lead wires and connector? Similar to Sealed lead Acid Batterys terminals与铅酸电池的导线相似 - Estimated quantity of the battery we will need: first trial order 50 units after sample approval; future order about 100 units per quarter如果样品通过了，先下50个订单，以后每个季度为100件。 Please note that we also need to buy 4 units of matching chargers per 50 batteries that can fully charge one battery in less than 12 hours 每50件电池需要4组匹配的充电器，充电时间小于12小时。 Our project customer used 2x 12V 185AH SLA batteries We intended to increase the capacity 5 times to extend the battery change-over time to up to 2 weeks. 我们打算把容量增加5倍，可以使电池工作2礼拜 My initial target customer s are in Germany. 我的最初客户是在德国 Since we intended to increase the capacity 5 times to extend the battery for a mobile temporary road LED sign to up to 2 weeks, we do need a n overall battery bank of 24V 800AH. So you may split it into two 12V 800AH or four 6V 800AH if your engineer see it suitable. 请给出解决方案