3、设备配置.pptVIP

Hardware Interfacing Survey Equipment测量设备设置界面 SURVEY HARDWARE CONFIGURATION测量硬件配置 SURVEY HARDWARE CONFIGURATION测量硬件配置 RS-232 Serial The most common interface.大多数的公共界面 Define your connection with:详细定义你的连接如下： Baud Rate:波特率 How fast is the device transmitting? Parity: 奇偶性Are there special characters tacked on the end of the message to check for bad transmisstion? Data Bits: 数据位 How many bits (zeroes and ones) are used to make up each message? Stop Bits:停止位 How many do you tack on to the end of each message to “frame” it? RS-232 Serial (cont.) Unless your device sends tons of data (multibeam echosounder, heave-pitch-roll sensor), set the communication settings on your equipment to 9600:N,8,1.除非你的驱动发送很多数据（多波束、船位升降、摆动传感器），设置你的设备信息为9600：N，8，1 If you have the baud rate wrong, you won’t read anything.假如你的波特率有错，你将无法读取任何信息 If you have the parity, stop bits or data bits wrong, you might be able to read an occasional message. 假如你的奇偶性、停止位、数据位有错，你可能能够读取非正常的信息 WCOM32 Serial Test ProgramWCOM32接口测试程序 RS-422 Serial – Long Distance Allows serial transmission over long distances.允许完全远距离连续传输 Can be wired directly into an RS-232 port.能直接连接到RS-232 端口 TX- to RX GND to GND Can use an RS-422 to RS-232 conversion adaptor. 能够使用RS-422 转换到 RS-232 连接 Binary Coded Decimal (BCD)二进制编码的十进制 Each digit isrepresented by four wires (1,2,4,8) 每个啊拉伯数字表示一条线 Computer can request measurement via strobe on some devices. 计算机要求测量经过那些设备 Some devices have a “Bad Data Flag” wire. 有些驱动程序有“缺陷数据标记”线 Every BCD device needs a slightly different cable. Check with Customer Support Group at Coastal.每个二进制编码的十进制驱动必需是一根不同的电缆，查看见Coastal.技术支持 Analog Devices These devices typically measure angles and/or depth of dredge sensors.这些驱动设备用于特殊的测量角度或挖泥船深度传感器 Analog sensors convert voltage or current (mA) to measurement values.类似传感器转换电压或电流到测量值 They require a special interface card (DAS 800/801/802), depending on the range of voltage or current.他们要求特殊的接触卡（ DAS 800/801/802）依靠电压或电流的变动范围 Some devices must be calibrated to take i