FreescaleKEA128汽车光控制模块参考设计.docxVIP

Freescale KEA128汽车光控制模块参考设计Freescale公司的Kinetis EA系列MCU是基于ARM核的高成本效益的汽车电子解决方案,适用于汽车各种应用如娱乐连接模块,停车辅助,DC/BLDC马达控制,TPMS,电动自行车CDI/EFI,电池管理,泵/风扇控制器,环境照明,BCM/HVAC,车窗/门/车顶,座位/镜/雨刷,动力总成姐妹芯片,传感器节点和发动机防盗系统.本文介绍了KEA128主要特性,框图,以及光控制模块参考设计KEA128LEDLIGHTRD主要特性和框图,电路图.Kinetis EA series MCUs for automotive provide cost-effective ARM?-based solution for a wide range of automotive applications and are pin-compatible across the Kinetis EA series and with future Kinetis automotive families.?This series includes a set of analog, communication, timing and control peripherals with varying flash memory size and pin count. These scalable devices are highly robust, and offer an enhanced ESD/EMC performance solution for cost-sensitive automotive applications. This series is supported by development tools, software and hardware references to help you quickly start designing.KEA128主要特性:? Operating characteristics– Voltage range: 2.7 to 5.5 V– Flash write voltage range: 2.7 to 5.5 V– Temperature range (ambient): -40 to 125℃? Performance– Up to 48 MHz ARM? Cortex-M0+ core– Single cycle 32-bit x 32-bit multiplier– Single cycle I/O access port? Memories and memory interfaces– Up to 128 KB flash– Up to 16 KB RAM? Clocks– Oscillator (OSC) - supports 32.768 kHz crystal or 4 MHz to 24 MHz crystal or ceramic resonator; choice of low power or high gain oscillators– Internal clock source (ICS) - internal FLL with internal or external reference, 37.5 kHz pre-trimmed internal reference for 48 MHz system clock– Internal 1 kHz low-power oscillator (LPO)? System peripherals– Power management module (PMC) with three power modes: Run, Wait, Stop– Low-voltage detection (LVD) with reset or interrupt,selectable trip points– Watchdog with independent clock source (WDOG)– Programmable cyclic redundancy check module (CRC)– Serial wire debug interface (SWD)– Aliased SRAM bitband region (BIT-BAND)– Bit manipulation engine (BME)? Security and integrity modules– 80-bit unique identification (ID) number per chip? Human-mach