STM32高级定时器日记之PWM.docVIP

STM32高级定时器PWM实用程序 文章来源：本站原创 作者：佚名 该文章讲述了STM32高级定时器PWM实用程序. 高级定时器与通用定时器比较类似，下面是一个TIM1 的PWM 程序,TIM1是STM32唯一的高级定时器。共有4个通道有 死区有互补。 先是配置IO脚： GPIO_InitTypeDef GPIO_InitStructure; /* PA8设置为功能脚(PWM) */ GPIO_InitStructure.GPIO_Pin = GPIO_Pin_8; GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP; GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz; GPIO_Init(GPIOA, GPIO_InitStructure); /*PB13 设置为PWM的反极性输出*/ GPIO_InitStructure.GPIO_Pin = GPIO_Pin_13; GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP; GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz; GPIO_Init(GPIOB, GPIO_InitStructure); /*开时钟PWM的 与GPIO的*/ RCC_APB2PeriphClockCmd(RCC_APB2Periph_TIM1,ENABLE); RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE); RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOB, ENABLE); /*配置TIM1*/ TIM_TimeBaseInitTypeDef TIM_TimeBaseStructure; TIM_OCInitTypeDef TIM_OCInitStructure; void Tim1_Configuration(void){ TIM_TimeBaseInitTypeDef TIM_TimeBaseStructure; TIM_OCInitTypeDef TIM_OCInitStructure;  TIM_DeInit(TIM1); //重设为缺省值 /*TIM1时钟配置*/ TIM_TimeBaseStructure.TIM_Prescaler = 4000; //预分频(时钟分频)72M/4000=18K TIM_TimeBaseStructure.TIM_CounterMode = TIM_CounterMode_Up; //向上计数 TIM_TimeBaseStructure.TIM_Period = 144; //装载值 18k/144=125hz 就是说向上加的144便满了 TIM_TimeBaseStructure.TIM_ClockDivision = TIM_CKD_DIV1; //设置了时钟分割 不懂得不管 TIM_TimeBaseStructure.TIM_RepetitionCounter = 0x0; //周期计数器值 不懂得不管 TIM_TimeBaseInit(TIM1,TIM_TimeBaseStructure); //初始化TIMx的时间基数单位 /* Channel 1 Configuration in PWM mode 通道一的PWM */ TIM_OCInitStructure.TIM_OCMode = TIM_OCMode_PWM2; //PWM模式2 TIM_OCInitStructure.TIM_OutputState = TIM_OutputState_Enable; //正向通道有效 PA8  TIM_OCInitStructure.TIM_OutputNState = TIM_OutputNState_Enable; //反向通道也有效 PB13 TIM_OCInitStructure.TIM_Pulse = 40; //占空时间 144 中有40的时间为高，互补的输出正好相反 TIM_OCInitStructure.TIM_OCPolarity = TIM_OCPolarit