the step.docVIP

the step-down start. In less energy consumption in the process of start, start a smooth, but need to be equipped with a dedicated power supply equipment, so the most frequently under the condition of medium and large for the dc motor. (6) inverter installation requirements 1. The frequency converter should be installed vertically, four weeks leave ventilated space. 2. Install the inverter of the base plate must be made of heat resistant material. 3. The adoption of forced air cooling frequency converter into the tuyere air filter should be set up. More than 4. The frequency converter in parallel arrangement, must leave enough space between Taiwan and Taiwan, generally should not be less than 50 cm. 5. The inverter cannot be installed in the combustible gases, explosive dangerous sites. 6. Frequency converter should be properly grounded, in order to improve the control sensitivity, noise, guarantee personal safety. (7) soft start device installation requirements 1. The soft starter shall be installed indoors. 2. Soft start device should be installed vertically, below should be standing on its more than 200 mm of space, good for heat dissipation. 3. After the soft starter input terminal connected to the power supply, when open load or open phase, can have very high induction voltage output, so it is strictly prohibited in the installation and debugging, maintenance and use of contact with the output end of the soft starter, lest cause accident getting an electric shock. Pick up by 4. In order to improve the power factor compensation capacitor must be put in the soft starter of the input. 5. Measure the insulation resistance motor, it must be three connections between soft starter and unlock the can. (eight) PLC installation requirements 1. To facilitate ventilation and tear open outfit, PLC should be left more than 80 mm of space around. 2. PLC should be installed vertically, not horizontal installation. 3. The installation of PLC should be far away from strong electr