钢结构英文翻译对照.docVIP

Steel structure 面积：area 结构形式：framework 坡度：slope 跨度：span 柱距：bay spacing 檐高：eave height 屋面板：roof system 墙面板：wall system 梁底净高: clean height 屋面系统: roof cladding 招标文件: tender doc 建筑结构结构可靠度设计统一标准: unified standard for designing of architecture construction reliablity 建筑结构荷载设计规范: load design standard for architecture construction 建筑抗震设计规范: anti-seismic design standard for architecture 钢结构设计规范: steel structure design standard 冷弯薄壁型钢结构技术规范: technical standard for cold bend and thick steel structure 门式钢架轻型房屋钢结构技术规范: technical specification for steel structure of light weight building with gabled frames 钢结构焊接规程: welding specification for steel structure 钢结构工程施工及验收规范: checking standard for constructing and checking of steel structure 压型金属板设计施工规程: design and construction specification for steel panel 荷载条件：load condition 屋面活荷载：live load on roof 屋面悬挂荷载：suspended load in roof 风荷载：wind load 雪荷载：snow load 抗震等级：seismic load 变形控制：deflect control 柱间支撑X撑：X bracing 主结构：primary structure 钢架梁柱、端墙柱: frame beam, frame column, and end-wall column 钢材牌号为Q345或相当牌号，大型钢厂出品：Q345 or equivalent, from the major steel mill 表面处理：抛丸除锈Sa2.5级，环氧富锌漆，两底两面，总厚度为125UM。表面喷涂防火材料，防火等级为：柱2小时，梁1.5小时 surface treatment: shot blasting to Sa2.5,zinc rich epoxy paint. 2primer paint and 2 finish paint .total dry film thickness 125um. Spraying fireproof painting on surface, for column 2hours and beam 1.5hours. 次结构包括：屋面檩条、围梁、门窗开口加强等，工厂轧制成C型、Z型截面，工厂预冲孔。Secondary structure included purlins, girts, roof opening and wall opening reinforcement, prepunched and rolled to C or Z section on factory machine. 材质：热浸镀锌卷材，Q345或相当牌号，大型钢厂出品或进口。Material : hot-dipped galvanized steel coil, Q345 or equivalent, from the major domestic steel mills or imported. 支撑系统：bracing sys 包括X型柱间支撑、屋面支撑、拉条及隅撑等。采用圆钢、钢管或角钢等。Bracing sys includes X bracing between columns, roof bracing, tie rods and angle bracing. Round bars, steel tubes or angle profiles are used. 屋面系统：roof sys 屋面外板：采用通过美国FM认证打开色镀锌SS360直立锁缝板，卷板为宝钢出品，24Ga厚，正常使用寿命为20年。Roof panel: FM certific